802.
1. Check the parts in your box CPE SET 1 DC 12V @ 1.25A Power Adapter 1 PoE DC Power Injector 1 Hose Clamps 2 CD user manual 1 2. How to fix the CPE on the Pole (1”- 1.
. PoE connection 1. Connect (POE) RJ45 Jack to CPE RJ45 Jack with good quality Ethernet cable. 2. Connect (LAN) Jack to PC or Switch Hub LAN port. 3. Plug in the power adaptor to PoE DC jack. 4. CPE Connection 1. Open the CPE enclosure you will find one RJ45 Jacks two LEDs and one reset button. 2. Connect the PoE cable to either LAN port. 3. To reset the CPE just press and hold the reset button for about 10 seconds and wait for 35 seconds to reboot the CPE.
The device has four operation modes (Gateway/Bridge/WISP/AP Client). Bridge/WISP/AP Client: The default IP addresses for the device are 10.10.10.254, so you need to make sure the IP address of your PC is in the same subnet as the device, such as 10.10.10.X. It will take about 25 seconds to complete the boot up sequence after power on from PoE. Gateway: The default IP addresses for the device are 172.32.1.
