User Guide
Screw
M4x30
Front panel
Spindle
American standard lock
Screw M4x20
Back shroud
Screw M4x30
Rear panel
Screw M4x12
Screw M3x8
Battery
compartment cover
Reset
Reset
Dot faces
the Arrow
Key board
Left
Cancel
Oled screen
Enter
Fingerprint
Sensor
Down/Reduce
Right
Up/Increase
Micro USB
charging port
Mechanical
keyhole
c. Low Level Alarm: whenever unlock, red light would blink and alarm would ring if the cell voltage is below 4.6V
(100 times are available to unlock even low level alarm).
a. Drill holes according to the hole draft.(fig.1)
1. Install the lock
b. Insert the lock into the door, tight up 2pcs self-tapping screws
M4X20.(fig.2)
The bolt faces to outside when unlock inside, vice versa.
2 fixed screws in line should be parallel to door edge.
a. The spindle should keeps the triangular arrowheads down.(fig.3)
2. Install the front panel
b. Tight up 3pcs screw M4X30 align to the hole.(fig.4 fig.5)
Pull the rope slowly at the other side of the door to go through
and fasten the front panel to the door.(fig.5)
Connection cable bypasses the lock and go through the hole.
Attention to the battery poles, and do not mix different batteries.
a. Install 4 new AA Alkaline batteries.(fig.11)
b. Screw into the fasten battery cover.(fig.11)
Fasten it when the edge of back shroud parallels to door edge.
Attention: the parts of back panel must not press to connection
cable when back panel fits to the door.
If the door thickness is over 50mm, the spindle spring turns to
other side.
3. Install the back shroud
b. The spindle hole of back panel aligns to the spindle to insert.
c. Fasten 4pcs M4X12 screws after alignment of back panel and back
shroud.(fig.10)
a. Connection cable goes through the back shroud and aligns to
the hole as the figure shows, fasten 3pcs M4X30 screws to the back
shroud.(fig.6)
b. Install the spindle, and the spring side should face to the rear
panel.(fig.7-8)
a. Ensure no loose of the connection cable to the connector port on
the inside plate.(fig.9)
4. Install the back panel
5. Install the Battery
To avoid the inconvenience of mis-installation, pls leave someone
in the room.
a. Complete the installation.
b. Add users for testing(refer to the instructions).
6. Complete the Installation
Self-Tapping
Screw
Fig.1 Fig.2 Fig.3 Fig.4 Fig.5
Dot Faces
The Arrow
X3
Screw M4X30
Dot faces
the Arrow
Reset
INSTALLATION INSTRUCTIONBREAKDOWN
STRUCTURE
b. Passwords Protection: The password is a combination of 6-8 digits. users could add any numbers before or after correct passwords.
Eg. user could unlock the door via passwords xxxxxx12345678- xxxxxx after pressing enter to confirm as 12345678 is the exact passwords.
Total digits must be less than 20.
a. Instruction to Unlock: fingerprint or 6-8 passwords to unlock (protect against peeping passwords)
X2
Fig.6 Fig.7 Fig.8
X3
Screw M4X30
42.9
54.9
unit：mm
Adjusting Spring Of
Thickness 50-60
Adjusting Spring Of
Thickness 30-50
Screw M3X8
X1
Fig.9 Fig.10 Fig.11