Quick Start Guide

ManualsBrandsArdomus ManualsElectronicsFlora Switch

Flora Switch Quick Start Guide

Product Introduction

Flora Switch (“Flora”) is a Zigbee built-in double relay switch designed to operate in locations

where the control of electric devices (up to 600W) are needed. The installed devices can also

be remotely controlled by mobile phone or other controllers. One typical application is to install

Flora between existing light sources and wall switch, besides control the light from existing wall

switch, you can also control the light from your mobile phone remotely.

Instructions

Fig1. Installation Wiring diagram

1. Flora has 8 wiring inputs as a picture shown below.

Summary of content (4 pages)

PAGE 1
Flora Switch Quick Start Guide Product Introduction Flora Switch (“Flora”) is a Zigbee built-in double relay switch designed to operate in locations where the control of electric devices (up to 600W) are needed. The installed devices can also be remotely controlled by mobile phone or other controllers. One typical application is to install Flora between existing light sources and wall switch, besides control the light from existing wall switch, you can also control the light from your mobile phone remotely.
PAGE 2
. Must TURN OFF the POWER to the light circuit at the circuit breaker to avoid the electrical shock. 3. On the 2 gang Lighting Switch (“LS”) which you want to control, you will find 4 wiring inputs for two loops. The first loop contains L1 and its COM (“L1-paired COM”) wiring input. The second loop contains L2 and its COM (“L2-paired COM”) wiring input. 4. To connect L1 of LS to S1 wiring input of Flora.And to connect L1-paired COM of LS to SA1 wiring input of Flora.
PAGE 3
Federal Communications Commission (FCC) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 4
EUROPEAN COMMUNITY (EC) The frequency, mode and the maximum transmitted power in EU are listed below: 2405 - 2480MHz: 16.218mW IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with CE RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.