Installation Guide

Table Of Contents

Select a location on the verticalwall to install

the bracket.

Mark anchor mounting hole locations on wall

as shown , ensure two screw holes are

horizontal.

Drill holes in the ﬁnished wall as required.

Press the anchors (1) into the holes.

secure the bracket (2) with the self-tapping

screws (3).

Make sure the bulge on bracket upwards

Slide the extension of the towel bar kit onto

the bracket .

Orient the screw hole of the extension

downwards.

Tighten the screw with the hex wrench to

secure the towel bar kit .

1.Put the towel bar (3)and (4) to connector (2),

tighten the bars by twisting connector(2).

2. Insure the towel bars are ﬁrmly installed on

the rack.

These products should be located and mounted to a wall.

While it is possible to mount them to any surface, a stud or concrete mounted product will yield the best results.

These products are not designed or intended for use as a grab bar or support bar. Do not install any of these

products in any area where they are likelyto be used inadvertenrly as a grab bar or support bar.

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Cleaning Instructions:

NOTE:

DANGER:(Risk of personal injury)

24"(612)

unit:inch(mm)

22"(557)

8"(200)

6.5"(164)

2.8"

(70)

2.2"x2.2"

(55x55)

4.3"

(109)

5.5"(139)

4050102

Towel rack

PAGE 1
Towel rack unit:inch(mm) 4050102 24"(612) 22"(557) 2.8" (70) 5.5"(139) 4.3" (109) 2.2"x2.2" (55x55) 8"(200) 6.5"(164) 4 3 2 1 1.Put the towel bar (3)and (4) to connector (2), tighten the bars by twisting connector(2). 2. Insure the towel bars are ﬁrmly installed on the rack. Select a location on the verticalwall to install the bracket. Mark anchor mounting hole locations on wall as shown , ensure two screw holes are horizontal. Drill holes in the ﬁnished wall as required.
PAGE 2
Towel rack unit:inch(mm) 4050101 24"(612) 22"(557) 3.2" (81) 4.9"(125) 4.1" (105) 2.2"x2.2" (55x55) 8"(200) 6.3"(161) 3 2 4 5 1 1.Insert the towel bar (3) and(5) into the towel rack (2) 2. Use a screw driver to tighten the screw (4). 3. Insure the towel bars are ﬁrmly installed on the rack. Select a location on the verticalwall to install the bracket. Mark anchor mounting hole locations on wall as shown , ensure two screw holes are horizontal. Drill holes in the ﬁnished wall as required.