User's Manual

Wireless Joey
Access Point™
INSTALLATION GUIDE
REGULATORY INFORMATION
FEDERAL COMMUNICATIONS COMMISSION NOTIFICATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Do not make changes or modifications to this equipment. This could void the user’s
authority to operate the equipment.
Product must be installed at least 20 cm (~8 inches) from typical person locations per FCC
RF exposure regulations.
Operation of Wi-Fi on channels 5150-5250 MHz is restricted to indoor use only.
If none of the remedies stops the radio interference, you should contact a licensed radio/
television technician, your satellite dealer, or call the Customer Service Center at 1-800-333-
DISH (3474), for assistance.
Copyright © 2014. EchoStar Technologies L.L.C., Englewood,
Colorado 80112. All rights reserved. DISH is a registered trademark
of DISH Network L.L.C. Other products, brands, and companies
mentioned are the Trademarks of their respective owner(s). This
product is designed in the United States and manufactured in India.
WELCOME
Thank you for buying the Wireless Joey Access Point™. The Wireless
Joey Access Point transmits the WiFi video signals from the Hopper to the
Wireless (WiFi) Joey. Please follow these instructions to connect your new
Wireless Joey Access Point. You can also visit http://mydish.com for additional
information on home networking.
PACKAGE CONTENTS:
Wireless Joey
Access Point
Power
WiFi signal
Ethernet
WPS
Power Supply
Installation Guide
For all your customer needs, go to
mydish.com/chat or call the
Customer Service Center at
1-800-333-DISH (3474)
Ethernet Cable
(10 foot cable)
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of
other channels is not possible.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other
antenna or transmitter except in accordance with FCC multi-transmitter
product procedures.
Devices will not permit operations on channels 120-132 for 11a and 11n/a which overlap the 5600 -
5650 MHz band.