Installation Guide

ManualsBrandsAquverse ManualsSmall Kitchen AppliancesCommercial-Grade Top-Load Water Dispenser Filtration System

A3000 Aquverse Water Cooler Troubleshooting Instructions Supplement

****Warning do not plug water cooler in until water bottle is in place and dispensing water through the faucets****

To find the Aquverse warranty please go to www.aquverse.com

Parts Extraction:

1. To Remove Baffle From Top of the Water Cooler

a. Turn the Baffle counter clockwise till the open arrow meets the corresponding arrow on the top of the cooler body (see

figure A and B below)

Figure A Figure B

b. Grip baffle from two opposite sides and pull upwards out of the cooler body (see figure C below)

Figure C

2. To Remove Faucets

a. Grip faucet in hand and unscrew faucet counter clockwise (see figure D below)

Figure D

General Information Helpful To Trouble Shooting

Summary of content (4 pages)

PAGE 1
A3000 Aquverse Water Cooler Troubleshooting Instructions Supplement ****Warning do not plug water cooler in until water bottle is in place and dispensing water through the faucets**** To find the Aquverse warranty please go to www.aquverse.com Parts Extraction: 1. To Remove Baffle From Top of the Water Cooler a. Turn the Baffle counter clockwise till the open arrow meets the corresponding arrow on the top of the cooler body (see figure A and B below) Figure A b.
PAGE 2
1. Note that your cooler is built with a no spill kit (see figure E below). This unit is designed to be used with a bottle that has a cap made to be punctured by our probe (see figure F below). The bottle cap (see figure G below) can be taken off if you also remove the no spill kit completely (see figure H below) Figure E Figure F Figure G Figure H 2. If cooler is not functioning make sure you are using a working outlet by testing it with a lamp What To Do If: 1. Cooler Is Not Dispensing Water a.
PAGE 3
b. Determine whether the compressor is working by putting your ear close to the top of the cooler with the bottle off (if you hear silence, the compressor is not working, if you hear a humming noise the compressor is working) c. Turn the thermostat all the way clock wise (see figure M below) Figure M 3. Cooler Is Not Dispensing Hot Water a. Check the back of the cooler, and make sure the hot tank switch is in the on position (see figure N below) Figure N b. Depress the hot tank reset button by: 1.
PAGE 4
. Using a chopstick or screwdriver, depress the hot tank reset button (water should be hot in 30 minutes time, see figure R below which pictures hole used to access hot tank reset button) Figure R 4. Water Is Leaking a. Identify the source of the leak (i.e. internal, faucets, or top) b. If the leak is coming from the top of the cooler check the water bottle to make sure there are no visible punctures, or pinholes.