Arabella ™ Aquastone™ Bathtub Installation & Care Manual USA and CANADA www.aquaticaplumbing.com E: info@aquaticaplumbing.
Arabella Aquastone Bathtub ™ ™ Use Home Depot PART “1 1/2” ABS Female Adapter Hub x FIPT or equivalent from another supplier The ABS female adapter features a hub x female NPT thread connection and provides a means for adapting a solvent weld connection to a threaded connection Extension Pipe & P-Trap (not supplied) 66.25” 44.0” 68.5” www.aquaticaplumbing.com E: info@aquaticaplumbing.com 30.25” Ø 2.0” 17.25” 45.0” 24.5” 16.25” 2.0” 19.0” 0.
Arabella Aquastone Bathtub ™ ™ 1 3 USA & CANADA INSTALL 2 15.125” min 0.393” min 0.393” 4a 4b 1.5 in.
Arabella Aquastone Bathtub ™ ™ TYPICAL FREESTANDING BATHTUB INSTALLATION PROCEDURE Before you start: • Ensure that the floor is even. • The wate-overflow fitting is supplied with the product, however other accessories like the slip joint and adaptors are not included and must be purchased separately. • Because of the technical features of the product, it should be used only with the supplied waste-overflow or specific 3rd party models that have been tested and approved by us.
Arabella Aquastone Bathtub ™ ™ INSTALLATION SEQUENCE continued 4 5 6 1.5” ABS DWV Hub x FIPT Female Adapter* • Picture 4: the water outlet pipe should be connected. • Picture 5: foot leveling lock nuts are adjusted. 7 • Picture 6: silicone is applied to the feet of the bathtub that stands on the floor. • Picture 7: when the installation is completed, the bathtub is taken down from the supports ( ie 2 x 4x4's).
Aquatica® Freestanding Bath Installer™ (Kit available separately - not included with bathtub) FEATURES • 18 Gauge Epoxy coated Metal Deck Flange • Designed to be installed in an 8” joist space • Can be installed with Waterproofing Membrane (*bronte™ NobleSeal TS Recommended) 93 " 8 238mm 11 " 4 32mm 41 " 8 103mm 2" 52mm • CSA Certified for Canadian and US markets KIT INCLUDES • 2 Brass tailpieces (Fine Thread and Flanged) • Freestanding Bath Installer™ assembly with 1-1/2” DWV ABS tailpiece • Cutting
Aquatica® Freestanding Bath Installer™ (Kit available separately - not included with bathtub) INSTALLATION INSTRUCTIONS Attaches to Freestanding Bath W/O 1 A. Cut 6-1/2” (16.5 cm) hole into wood sub-floor (use supplied Cutout Template). B. Measure and cut ABS Tailpiece as necessary to ensure a secure connection to P-Trap below. C. Insert Freestanding Bath Installer™ assembly into floor opening and connect to Pipe below. D. Affix to sub-floor with 6 screws (not supplied) 2 A.
Arabella™ - Maintenance Instructions Arabella™ - Инструкция по уходу ™ Arabella - Installation Hooldus juhend PAA Ltd., Unijas street 12A, Riga, Latvia 13 EN 14516 CL1 CA-DA PAA-BT-SILKS-19/2013 & Entretien Arabella™ - Manuale per il corretto mantenimento Arabella™ - Instrucciones para la correcta manutención max.