Specifications

BT-1 manual

Specification:

Input Voltage: 9.6-14.4V

Current rating: < 5A

Speaker impedance: 4 ohm or above

Connecting to Bluetooth

Check for BT144 broadcast name and select with a passcode 0000.

After connection successful, a beep tone will be heard.

Functions

 Power ON/OFF: Long press to turn ON. Short press to turn OFF

 Volume Control: Press + or – to increase volume or decrease volume. Long press

+ or – will reduce volume continuously.

 Fast forward / Fast Rewind: Press once to skip to next or last song. Long press to

rewind or forward continuously.

 External Trigger: Press once or to activate the external EXT1 or EXT2.

After triggered, the EXT1 or EXT2 will provide 12V voltage. The EXT1 and EXT2

will toggle the output between 12V and 0V.

 Play/Pause: Use to play or pause the music.

PAGE 1
BT-1 manual Specification: Input Voltage: 9.6-14.4V Current rating: < 5A Speaker impedance: 4 ohm or above Connecting to Bluetooth Check for BT144 broadcast name and select with a passcode 0000. After connection successful, a beep tone will be heard. Functions      Power ON/OFF: Long press to turn ON. Short press to turn OFF Volume Control: Press + or – to increase volume or decrease volume. Long press + or – will reduce volume continuously.
PAGE 2
Wire Connection Connection will be as above figure. Do not connect speaker with impedance lower than 4 ohm. Electronic Crossover There is a red wire in a loop. When the red wire loop is cut, the rear speaker will be used to drive a subwoofer (4 ohm or above subwoofer speaker).
PAGE 3
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.