User Manual AP-013II II 2.
Index Safety Notice 1 Foreword 2 5. Extra Functions 10 Zone Control 10 Relay Mode 11 Interlink Triggering Mode 12 1. Product Introduction 3 Main Features 3 Multi-Camera Control 13 2. Components 4 Compatibility 13 Body 4 6. Specifications 14 Accessories 4 3. Getting Started and Basic Operation 5 Ordering Options 5 Battery Installation 5 Modes 5 Triggering Range Setting 5 Channel Setting 6 Test Triggering 6 Indicator Lights 7 4.
Foreword Safety Notice To prevent damage to your product or injury to yourself or to others, read the following safety precautions in their entirety before using this equipment. Keep these safety instructions where all those who use this equipment will read them. Thank you for purchasing Aputure Trigmaster Plus II. It's an exciting new flash trigger full of features to improve your photography. Read this user manual to better understand your new Trigmaster Plus II and maximize your shooting skills.
3. Getting Started and Basic Operation Test Triggering Ordering Options Local Test (Uses 1pcs TP2) 1) Order an extra unit as receiver. 2) Order extra shutter cables to control different cameras. 3) Order 3 or more units to take advantage of zones and relay mode. Press TEST button of unit on the flash (this unit should be set to RX) to trigger the flash. Battery Installation Tp2 uses 2 AA batteries, which can last up to 80 hours.
Indicator Lights 4.
Remote Shutter Control 1) Wired Shutter Control TP2 can act as a wired shutter release. You only need one unit for this. 1. Set TP2 to TX/RX mode. 2. Connect shutter cable between camera and 'CAMERA/PC' port on TP2. 3. Half press TP2's trigger button to autofocus. 4. Full press trigger button to fire the camera shutter. 1. Set both units to TX/RX and the same channel. 2. Set camera to appropriate mode (either Continuous drive mode or Bulb mode) 3.
3) Switch between zone A and C on the transmitter to control the flash of your choice. 4) Press camera shutter to fire either corresponding flash. Note: 1. Set zones to control multiple flashes or cameras, but not when controlling a single camera. 2. Transmitter (TX/RX) can use up to all 4 zones. Receiver (RX) can use only one zone. 2. Set 1st triggering unit to TX/RX. 3. Set 2nd and 3rd units to RX. 4.
Note: 1. Set all units to the same channel. 2. Can use zones to trigger more flashes in this mode. Just set zones on the shutter camera trigger or flash transmitter and no need to set zones on the handle trigger. Multi-Camera Control TP2 can fire multiple camera shutters at the same time, by pressing the shutter button on your primary camera. This is useful for getting multiple angles at once. 1) Place 1st unit on primary camera (TX/RX). 2) Place other units on as many cameras as you wish (RX).
8. Trouble Shooting Unable to trigger flash. Ensure enough battery power. Set the transmitter and receiver to the same channel and zone settings are correct. Make sure the transmitter and receiver are set to the correct mode (TX/RX or RX). Make sure the hot shoe mount or PC cable are completely connected. Make sure the speedlite or strobe flash are compatible with TP2. Make sure recycle time of your flash is ready. Unable to fire the shutter. Ensure enough battery power.
Company: Aputure Imaging Industries Co., Ltd Name: Aputure Trigmaster Plus II Model Number: TXII-set FCC ID: 2AABZTXII-SET This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
