DOCUMENT NAME: WPC User Manual Introduction
The Wireless Phone Charger is a Confort systems used to provide battery charging capability to commercial compatible Smarthphones. Phones not equipped with wireless charging receivers can often be supplemented with a shell that makes wireless charging possible. The Wireless Charger can act as a NFC reader to communicate with a NFC tag. The general performance of WPC is listed as follow, Wireless operating frequency：127.7KHz ；Wireless maximum transmitted power：10W Maximum transmit power value: 127.7kHz：14.
Vehicle Mounting location The WPC is located in the center tunnel console of the vehicle. The WPC is located in such way that the compatible device (phone) can be placed and removed easily from the end user. The charging face (coil face) of the WPC is facing the A pad area where the phone is placed. Mobile phone(receiver coil) Pad WPC(Transmitter coil) Getting Started The WPC is able to start charging once following conditions are met: a) The WPC is correctly connected and energized.
1.The Smart Phone (Compatible Device) shall be placed as much centered as can be in the charging area to initiate the charging, however the WPC has three coils (up-center-down) to start the charging even the device is not completely centered. The charing area surface shall be parallel to the rear face of the Compatible device. 2.We control the 3 coils through the enable signal of coil top, coil center and coil bottom.
the WPC has the hability to stop charging if there is a foreign object between the phone and the charging surface area. Most of these objects are identified by the WPC but in general any object (specially ferromagnetic Objects) between the charging area and the Compatible device shall be avoided for the WPC to work normally.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Importer Name:_________________________________________ Importer Address:_________________________________________________
