Whitepaper

The above two pages should be printed (doublesided) on 38 lb glossy white paper.

The prints should be cut to size accoridng to the dimensions on this document (15.81 x 3.93”).

The prints should also be folded in thirds along the dotted lines shown above like an accordion fold.

The dotted lines are not to be printed.

The dark blue panel that says “Metrix Reader” with the helix is the front.

THIS PAGE IS NOT TO BE PRINTED

PAGE 1
The above two pages should be printed (doublesided) on 38 lb glossy white paper. The prints should be cut to size accoridng to the dimensions on this document (15.81 x 3.93”). The prints should also be folded in thirds along the dotted lines shown above like an accordion fold. The dotted lines are not to be printed. The dark blue panel that says “Metrix Reader” with the helix is the front.
PAGE 2
™ Start Here 01 Scan QR code for interactive instructions and video demonstration. Metrix Reader Quick Start Guide Indicates flashing light Starting Up Positive Result The reader is starting up. Wait until the center light is solid white before inserting a sensor. The test is complete and SARS-CoV-2 was detected in the sample. Ready Negative Result The reader is ready to start a test. The test is complete and SARS-CoV-2 was NOT detected in the sample.
PAGE 3
Troubleshooting Indicates flashing light Test Error No Power Remove sensor and firmly press down on collector. Firmly reinsert sensor into reader. If error persists, discard sensor and use a new test kit. Check all electrical connections. The reader is not receiving power. Canceled Test The test did not complete. Discard the sensor and run the test with a new test kit. IVD Hardware Failure For support, please contact us at: There is an error with the reader. Disconnect and reconnect the power. 1.