User guide

ManualsBrandsApricorn ManualsStorageAegis Bio 3.0 - Solid State Drive

Quick Start Guide

Basic LED States

LOCK RED LED

UNLOCK GREEN LED

ADMIN BLUE LED

ENROLL Button

Solid RED = Standby, swipe nger to unlock

Flashing RED = Error

Solid BLUE / Flashing GREEN = Ready to enroll ngerprint

Solid GREEN = Drive unlocked

Flashing GREEN = Disk activity

Aegis Bio 3.0

Swiping your Finger

To successfully swipe your nger,

start your swipe by placing your

ngertip on the downward facing

arrow at the top of the biometric

sensor. Swipe your nger in a

downward motion across the

sensor. If your swipe is successful

the GREEN LED will start to icker.

Start

swipe

here

Summary of content (4 pages)

PAGE 1
Aegis Bio 3.0 Quick Start Guide 1 LOCK RED LED 2 UNLOCK GREEN LED 3 ADMIN BLUE LED 4 ENROLL Button 4 Start swipe here Swiping your Finger To successfully swipe your finger, start your swipe by placing your fingertip on the downward facing arrow at the top of the biometric sensor. Swipe your finger in a downward motion across the sensor. If your swipe is successful the GREEN LED will start to flicker.
PAGE 2
Getting Started - Out of the Box TIP: We highly recommend that you enroll at least three different fingers to ensure access to the drive in the case that your primary finger cannot be used. 1. Attach the integrated USB cable of the Aegis Bio to an available USB port on your computer. The Aegis Bio LEDs will show Solid BLUE and Flashing GREEN indicating that the drive is ready to enroll your fingerprint. 2. Swipe your Finger.
PAGE 3
Unlocking the Aegis Bio Once your fingerprints are enrolled, unlock the Aegis Bio using the directions below. 1. Attach the integrated USB cable of the Aegis Bio to an available USB port on your computer. The Aegis Bio LED will show Solid RED indicating that the drive is locked and is in Standby mode. 2. Swipe your Finger. The RED LED will turn off while the GREEN LED will start to flicker briefly as the Aegis Bio processes your fingerprint. 3.
PAGE 4
Enrolling a new finger If there are less than 5 fingerprints enrolled and you want to enroll a new finger, follow the instructions below. 1. Plug in the Aegis Bio to a USB port on your computer. The LED should be Solid RED indicating that the drive is Standby mode. 2. Push the ENROLL button for 3 seconds. If less than 5 fingerprints are enrolled, the BLUE LED will become Solid BLUE and RED LED will remain illuminated. Proceed to Step 3.