User's Guide

Table Of Contents

600890-000072, rev 0.2, 10/06/20 Page 1 of 3

GALEO

User Guide

Compliance

• This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

• Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

• Changes or modifications not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

• This device meets the FCC requirements for RF exposure in public or uncontrolled environments for

extremity exposure conditions.

• FCC ID: 2AETC-GALEO

Getting Started

About Galeo

Galeo is a system used to track your bike. It consists of a bike-mounted device and a smartphone app that is

used to communicate with the device.

Compatible Devices

Visit FindGaleo.com for a list of compatible devices.

Powering on and Charging Galeo

Plug in the device to a wall outlet or computer USB port using the included USB cable to wake it up from

shipping mode. After that, the unit is always on unless it is powered off in the app.

Make sure that your device is fully charged before using it. The light on the device will blink when it’s charging,

and shine steady when it’s fully charged.

PAGE 1
GALEO User Guide Compliance • This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 2
Galeo User Guide Downloading the Galeo app To interface with Galeo, download the Galeo app from the App Store® or Google Play Store and install it onto your phone. Setting up Galeo Follow the steps below to set up your Galeo for the first time. IMPORTANT: When prompted, make sure to allow Galeo to use your location and bluetooth. This enables the app to communicate with the device. 1. Open the Galeo app and follow the on-screen steps to create an account. Then, log in to the account. 2.
PAGE 3
Galeo User Guide Location Accuracy The colored circle around the device on the map indicates the area that the device is located in. Circle Color Orange Green Red Meaning Shows location based on its precise GPS location. Shows location based on the cell tower that it’s pinging. If a GPS location fails, you will get the option to view its cell tower location. This is a less precise location than the orange GPS location. The app failed to find the location of the device.