AT-130 INSTALLATION MANUAL Document revision: 0.
AT-130 Installation Manual AT-130 Installation Manual © 2020-21 Appareo Systems, LLC. All Rights Reserved. AT-130 Installation Manual. All content within is copyrighted by Appareo Systems, LLC, and may not be reprinted without permission. The content of this manual is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Appareo Systems.
AT-130 Installation Manual 1. Compliance • This device complies with part 15 of the FCC Rules and applicable RSS standards. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • Le présent materiel est conforme aux CNRexempts de licence d'Industrie Canada.
AT-130 Installation Manual 2. About AT-130 The Appareo Asset Tracker, model AT-130 is a cost-effective, cellular, IP69K-rated asset tracking device with ultra-long battery life and industrial operating temperature range (-40 ℃ to +85 ℃). 3. Activating AT-130 In order to use AT-130, you need to activate it. 1. Peel off the clear label on the back of the unit shown below. Flip over the unit to remove the magnet. 2. Put the magnet in the Device Activation slot for five seconds.
AT-130 Installation Manual 4. Installing AT-130 Installation Location Choose an installation location that meets the following specifications: • Mounted on a clean, flat surface. • Mounted as high up as possible. • The top (recommended) or top side of the unit has a clear view of the sky (not underneath or blocked by a metal surface). • The device shall be installed so on the equipment so that the operator is, at minimum, 20 cm away from all external surfaces of the device.