Instructions / Assembly

INSTRUCTION SHEET

PEX

Quick Pinch Clamp Tool

PEX

69PTKG1096

1. Cut PEX tubing square, leaving a clean, even

edge. Remove any burrs.

2. Slip PEX pinch clamp over tubing and insert

ﬁtting. Place pinch clamp 1/8” below edge

of tubing.

3. Place PEX pinch clamp nub between tool

jaws and ratchet the clamp until the PEX

Pinch Clamp Tool auto-releases. This action

will assure that the PEX pinch clamp is fully

engaged.

4. Pressure test the PEX tubing and inspect

before burying or normal use. If there are

any signs of leaks, repeat the total

procedure.

For use with Apollo

, Watts

, Murray

, and Oetiker

PEX cinch clamps.

Do not use with Zurn

Qickclamp

™

PEX crimp rings.

Apollo® PEX Pinch Clamps

PXPC3810PK 3/8" 10 Pack

PXPC1210PK 1/2" 10 Pack

PXPC1225PK 1/2" 25 Pack

PXPC12100PK 1/2" 100 Pack

PXPC3410PK 3/4" 10 Pack

PXPC3425PK 3/4" 25 Pack

PXPC34100PK 3/4" 100 Pack

PXPC15PK 1" 5 Pack

PXPC110PK 1" 10 Pack

PAGE 1
PEX INSTRUCTION SHEET 69PTKG1096 PEX Quick Pinch Clamp Tool 1. Cut PEX tubing square, leaving a clean, even edge. Remove any burrs. 2. Slip PEX pinch clamp over tubing and insert fitting. Place pinch clamp 1/8” below edge of tubing. 4. Pressure test the PEX tubing and inspect before burying or normal use. If there are any signs of leaks, repeat the total procedure. For use with Apollo®, Watts®, Murray®, and Oetiker® PEX cinch clamps. Do not use with Zurn® Qickclamp™ PEX crimp rings. 3.
PAGE 2
PEX INSTRUCTION SHEET 69PTKG1096 PEX One Hand Pinch Clamp Fastening Tool Calibration Apollo PEX tools are pre-calibrated for up to 10,000 uses. After repeated use of this tool, it may require calibration. A calibration gauge and bar is provided with the tool. 1 2. Use the Calibration Tool to gauge the jaw gap. Ideally, the jaw gap should be between 0.8 mm and 1.2 mm. 2 If the 1.2 mm side of the gauge slides into the gap, then the jaw space is too large. If the 0.