RFID Module Installation Manual Series 500 Reader Installation Version 1.03 Last Revision: 5/11/2009 Copyright 2009 API Healthcare Corporation.
Purpose This document describes the installation process of the RFID Module (iCLASS) in the Series 500 Reader. This module is an option that may be purchased by the customer. NOTICE: Installation of this module may only be made by qualified API employees. This is not a field upgrade, and must be done at the API factory. FCC Notice FCC ID: W7N-PROXIC01 Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.
2. Solder the header into the pins shown in Figure 1 on the solder side of the Series 500 main PCB. It will be necessary to slightly adjust the spacing of the pins. Note this header is used only for mechanical fastening. There is no electrical connection. 3. Cut the free ends of the header to .1” length. 4. Place double sided foam at the location indicated in Figure 1. Figure 1. 5. Place the module so the header pins line up with the mounting holes on the module. 6.
Figure 2. 8. Connect the cable from the iCLASS RFID module to the COM2 connector as shown in Figure 3. 9. Mount the Series 500 Main PCB in the case in the normal manner. 10. Complete final assembly of the unit. Last Revision: 5/11/2009 Copyright 2009 API Healthcare Corporation.
Figure 3. Testing the RFID Module 1. Apply power and wait for the unit to boot up. 2. Enter Diagnostic Mode: a. Hold the F1 key until the display shows: DIAGNOSTIC PIN b. Enter the PIN number by pressing the following keys: 415049 c. Press 1 (BADGE) d. Press 1 (RAW DATA) 3. Hold the test badge near the front plate of the reader until it displays: PROX SUCCESS. 4. Verify the number displayed matches the number printed on the test card. 5. This completes test of the module.