HID Prox RFID Module Installation Instructions Series 500 Reader Installation Version 1.00 Last Revision: 6/25/2009 Copyright 2009 API Healthcare Corporation.
Purpose This document describes the installation process of the HID Prox RFID Module in the Series 500 Reader. This module is an option that may be purchased by the customer. NOTICE: Installation of this module may only be made by qualified API employees. This is not a field upgrade, and must be done at the API factory. FCC Notice FCC ID: W7N-PROXHI01 Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.
b. Pull out the center pin on each of the four 3-pin segments. This will leave only the 2 outer pins. (Save the unused segments for other Prox Boards.) c. Use a modified 3-pin segment and insert the short side of the pins into the bottom 2 holes of the J8 connector, numbers 1 and 2, on the 50 circuit board. Solder them in place. d. Insert the short side of a single pin segment, into each of the top 2 holes, numbers 4 (CLK) and 5 (DATA) of the 50 circuit board. Solder them into place. e.
. Verify the number displayed matches the number printed on the test card. 5. This completes test of the module. Last Revision: 6/25/2009 Copyright 2009 API Healthcare Corporation.