Casi-Rusco RFID Module Installation Manual Series 500 Reader Installation Version 1.00 Last Revision: 4/16/2010 Copyright 2009 API Healthcare Corporation.
Purpose This document describes the installation process of the Casi-Rusco RFID Module in the Series 500 Reader. This module is an option that may be purchased by the customer. NOTICE: Installation of this module may only be made by qualified API employees. This is not a field upgrade, and must be done at the API factory. FCC Notice FCC ID: W7N-PROXCR01 Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.
Figure 1. 2. Insert the short pins of the two headers into the module. Note that the center hole is left empty. You might need to bend the pins slightly to fit through the holes. Solder the pins. Use care not to damage the antenna while soldering. 3. Remove the paper back and install a 1-1/4” X 1-3/4” plastic insulator over the circuit board. Figure 2. 4. Trim the excess lengths of the pins and solder. Last Revision: 4/16/2010 Copyright 2009 API Healthcare Corporation.
Figure 3. 5. Mount the Series 500 Main PCB in the case in the normal manner. Figure 5. 6. Complete final assembly of the unit. Testing the RFID Module 1. Apply power and wait for the unit to boot up. 2. Enter Diagnostic Mode: Last Revision: 4/16/2010 Copyright 2009 API Healthcare Corporation.
a. Hold the F1 key until the display shows: DIAGNOSTIC PIN b. Enter the PIN number by pressing the following keys: 415049 c. Press 1 (BADGE) d. Press 1 (RAW DATA) 3. Hold the test badge near the front plate of the reader until it displays: PROX SUCCESS. 4. Verify the number displayed matches the number printed on the test card. 5. This completes test of the module. Last Revision: 4/16/2010 Copyright 2009 API Healthcare Corporation.