R E M O T E -R C O N T R O L L E R FOR USE WITH THE MODEL 1788 8-CHANNEL MICROPHONE PREAMPLIFIER USER’S GUIDE
R E M O T E -R C O N T R O L L E R Copyright©1999 by Aphex Systems, LTD. All rights reserved. All Aphex products are trademarks or registered trademarks of Aphex Systems, LTD. Other brand and product names are trademarks or registered trademarks of their respective holders.
TABLE OF CONTENTS 1.0 INTRODUCTION 1.1 The Model 1788-R Remote Controller 1.2 The 1788-R Remote Controller at a Glance 1.3 Quick Setup 2.0 FUNCTIONS 2.1 Overview 2.2 Selection and Validation Block 2.3 Preset Handling Block 2.4 Secondary Functions 5.0 4 6 8 8 9 3.0 INTERFACING 3.1 Interfacing 3.2 When Using the 1788 Remote Program 4.0 4 WARRANTY 4.1 Limited Warranty 4.
R E M O T E -R C O N T R O L L E R 1.0 INTRODUCTION 1.1 THE MODEL 1788-R REMOTE CONTROLLER To control up to sixteen Model 1788 8-Channel Microphone Preamplifiers from a remote location we created the Model 1788-R Remote Controller. The 1788-R has been designed to closely match the layout of the Model 1788, ensuring easy and familiar operation.
1.0 INTRODUCTION LOCAL BLOCK Gain Select Determines the function of the GAIN control; Input, Main Output or Aux Output. Channel Status Readout Displays input and output gains settings, headroom, and function status. Channel Select Chooses one of eight channels from the currently selected unit. Mute Shut down the analog output of the selected channel. All functions can be adjusted while a channel is muted. This does not effect digital output on Model 1788.
R E M O T E -R C O N T R O L L E R 1.3 QUICK SETUP The following instructions are a quick start for setting up the 1788-R with a single Model 1788 or a bank of Model 1788s. The Model 1788s should already be installed. If they are not installed, refer to the Model 1788 User’s Guide. To interface the 1788-R, it must first be connected to the power supply via a DB-25 connection. Use either the supplied parallel cable or any standard parallel DB-25 cable.
1.0 INTRODUCTION The following step-by-step instructions will first assist you in configuring the Model 1788(s) into a system so they will be recognized by the 1788-R and then you are guided through a comm test procedure. Finally, we show how presets are created, loaded and changed. On the Model 1788 1. Tap the LOCAL CONTROL button (so it illuminates) on all connected Model 1788s. 2.
R E M O T E -R C O N T R O L L E R 2.0 FUNCTIONS 2.1 OVERVIEW The 1788-R Remote Controller provides all the functions from the Model 1788’s Local Block and Test Tone Block. For complete details on the functions in both these blocks, refer to the Model 1788 User’s Manual. A quick reference to these basic functions is found in this manual’s Section 1.2 -The 1788-R Remote Controller at a Glance.
2.0 FUNCTIONS 2.3 PRESET HANDLING BLOCK In applications using multiple Model 1788’s, such as theater and live concerts, it is critical that mic preamp settings can be stored and changed quickly as Presets. The Model 1788-R is a state-of the-art solution that not only duplicates the key functions of the Model 1788 but provides a means to quickly recall a series of settings that are used in every performance.
R E M O T E -R C O N T R O L L E R Activating the PRESET EDIT button (illuminates when activated) allows a user to edit an existing preset(s) without transmitting control data. This means that a preset can be selected and modified using the Local Block without actually transmitting the changes to the selected unit. This makes it possible to change settings for an upcoming preset, for example the next preset used in a live show, without interfering with the current settings of the connected Model 1788s.
2.0 FUNCTIONS 2.4 SECONDARY FUNCTIONS The 1788-R has a set of functions not directly accessible from the front panel. These functions, named secondary functions, are accessed by pressing down both TEST TONE buttons and a pre-designated CHANNEL SELECT button. To Exit this mode, press any key. CLIP/LIM MEMORY FUNCTION. (Press both TEST TONE buttons and CHANNEL SELECT #6).
R E M O T E -R C O N T R O L L E R 3.0 INTERFACING 3.1 INTERFACING The main advantage of the Model 1788 is its ability to be controlled remotely, allowing the unit to be located near the microphones, providing many sonic and operational benefits. The audio industry has accepted for years the necessity of running microphone lines from the microphone back to the mix position. Once at the mixing console (or dedicated microphone preamp) the microphone levels are amplified to line levels.
3.0 INTERFACING Note: The baud rate for the RS-232/RS-422 is fixed at the factory to the default 19.2kHz on the 1788-R to match our proprietary 1788 Remote Program for PCs. Refer to Section 5.8 in the Model 1788 Users Manual for details on MIDI protocol and MIDI commands with respect to controlling Model 1788s remotely.
R E M O T E -R C O N T R O L L E R PC TO 1788-R (PRIME CONTROLLER) TO MODEL 1788 PRIMARY CONTROLLER To 1788R Controller TO CONTROLLER TO 1788-R CONTROLLER TO PREAMP RS-232 RS-232 RS-422 RS-422 UTIL 1 2 3 4 ON MIDI OUT IN THRU MIDI OUT P < IN ˙ ˙ UTIL THRU Link In RS-422 ADAT Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3 Ch 2 IN WORD OUT CLOCK ˙ Ch 1 ˙ OPTICAL Link Out RS-422 SECONDARY CONTROLLER AUX OUTPUT ON 90-260 VAC 50/60 HZ 60 WATTS PC running proprietary 1788 Remote Program A
4.0 WARRANTY 4.1 LIMITED WARRANTY Aphex Systems, Ltd. warrants to the original purchaser that the Model 1788 will be free from defects in materials and workmanship for a period of one (1) year from the date of purchase. The above warranty is in lieu of any other warranty, whether expressed, implied or statutory, including, but not limited to, any warranty of merchantability, fitness for any particular purpose, or any warranty arising out of any proposal, specification or sample. Aphex Systems, Ltd.
5.0 SPECIFICATIONS CONNECTORS Type: “To Controller” RS-232, RS-422, MIDI “To Controller” RS-232, RS-422 OTHER Power 60 VAC Dimensions 3.5” H x 19” W x 13.25” D (88.9mm x 482.6mm x 336.55mm) Weight 2 lbs. Aphex Systems, Ltd. • 11068 Randall Street • Sun Valley, CA 91352 PH: (818) 767-2929 FAX: (818) 767-2641 Copyright©1999 by Aphex Systems, LTD. All rights reserved. All Aphex products are trademarks or registered trademarks of Aphex Systems, LTD.