Aperio® AH40 Hub Installation Guide Experience a safer and more open world 1
AH40 - Table of Contents AH40 - FCC and ISED Canada Statements.......................................................... 3 AH40 - Placement of Communication Hub...................................................... 5 AH40 - Mounting, Americas Adapter Plate....................................................... 6 AH40 - Mounting, Bottom Cover.......................................................................... 7 AH40 - Connectors...........................................................................
AH40 - FCC and ISED Canada Statements FCC Statements Changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
AH40 - Placement of Communication Hub <2 5m /~ 80 ft Example of placement of the Hub with 8 locks. AH40 can manage up to 64 locks Note: AH40 must be installed into a junction box ex European 2-Gang, Aperio bottom cover or with Americas adapter plate to junction box. AH40 must be installed by qualified and trained personal.
AH40 - Mounting, Americas Adapter Plate (US version) AH40 - Mounting, Americas Adapter Plate 1 Americas Adapter Plate 2 3 Screw (4 x 35 mm) 4 5 Screw (3 x 10 mm) Top Cover Option External Antenna 6
AH40 - Mounting, Bottom Cover AH40 - Mounting, Bottom Cover (EU version) 1 Screw (4 x 35 mm) 3 Bottom Cover 2 Screw (3 x 10 mm) Top Cover Option External Antenna 7
AH40 - Connectors PAIR J200 J400 8-24V INT EXT J800 J700 - + S100 Connectors Description Ethernet connector. Connection to the Electronic Access Control system through a 10BASE-T / 100BASE-TX Local J700 Area Network. Can also be used for power supply if connected to a IEEE 802.3.af compliant Power Sourcing Device (PSE). Wire requirements CAT5 or higher. Power supply input, 8-24 VDC, 1.2 W. The power supply J800 shall be 3 A over current protected. Wire requirements 16-22 AWG.
AH40 - Jumpers PAIR J200 J400 8-24V INT EXT J800 J700 - + S100 Jumpers J400 ANTENNA Description Select external antenna by connecting the two right pins. Select internal antenna by connecting the two left pins. Select pairing mode by connecting the two right pins. J200 PAIR Note: If the pairing jumper if removed within 10 seconds from from boot up and the Hub LED is lit, all paired devices will be unpaired.
AH40 - Communication Hub LED Indications The Communication Hub has a status LED visible through the front cover. It supports optical schemes with red, green and yellow.
AH40 - Technical Data Physical Dimensions 82 mm x 82 mm x 37 mm (H x W x T) Power Supply 8-24 VDC or Power over Ethernet (PoE) Power Rating The power supply shall be able to deliver minimum 1.2 W and be 3 A over current protected. Wire requirements 16-22 AWG. PoE IEEE 802.3.af compliant class 1 Powered device (PD) Ethernet 10BASE-T / 100BASE-TX Local Area Network Radio Standard IEEE 802.15.
www.assaabloy.