User Manual

ManualsBrandsAPC ManualsComputer Accessories & PeripheralsAPC Back-UPS Pro 1500VA UPS Battery Backup & Surge Protector (BR1500G)

8Installation and Operation

Back-UPS

™

Pro 1300G/1500G

Connect the Battery

Install PowerChute

™

Personal Edition Software

APC PowerChute Personal Edition software provides automatic file saving and shutdown of your

computer in the event of a power failure. Use the cable supplied with the Back-UPS to connect the data

port on the Back-UPS to the USB port on your computer. Place the CD into your computer, and follow

the on-screen instructions.

Inventory Safety and General Information

Inspect the package contents upon receipt. Notify the

carrier and dealer if there is any damage.

Read the Safety Guide supplied with this unit before

installing the UPS.

• This UPS is intended for indoor use only.

• Do not operate this UPS in direct sunlight, in contact with fluids, or where there is

excessive dust or humidity.

• Be sure the air vents on the UPS are not blocked. Allow adequate space for proper

ventilation.

• The battery typically lasts for three to five years. Environmental factors impact

battery life. Elevated ambient temperatures, poor quality AC power, and frequent

short duration discharges will shorten battery life

• Connect the UPS power cable directly to a wall outlet. Do not use surge protectors

or extension cords.





bu001b

Us e r Doc ument atio n

bu055a

bu057a

bu059a

bu058a

bu060a

Us er D o cu me n ta t i on

Summary of content (8 pages)

PAGE 1
8Installation and Operation Back-UPS™ Pro 1300G/1500G Inventory Safety and General Information Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage. Read the Safety Guide supplied with this unit before installing the UPS. bu001b • This UPS is intended for indoor use only. • Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive dust or humidity. • Be sure the air vents on the UPS are not blocked.
PAGE 2
Connect the Equipment Battery Backup and Surge Protected outlets When the Back-UPS is receiving input power, the Battery Backup with Surge Protection outlets will supply power to connected equipment. During a power outage or other utility problems, the Battery Backup outlets receive power for a limited time from the Back-UPS. Connect equipment such as printers, FAX machines, scanners, or other peripherals that do not need battery backup power to the Surge Protection Only outlets.
PAGE 3
Operation Power Saving Function To conserve electricity, configure the Back-UPS to recognize a Master device, such as a desktop computer or an A/V receiver, and Controlled peripheral devices, such as a printer, speakers, or a scanner. When the Master device goes into Sleep or Standby mode, or is switched OFF, the Controlled device(s) will be switched off as well, saving electricity.
PAGE 4
Front Panel Buttons and Display Interface Use the three buttons on the front panel of the Back-UPS and the display interface to configure the Back-UPS.
PAGE 5
Warnings and System Faults Audible Warnings Back-UPS is running on battery. You should consider saving any work in progress. Low battery condition and battery run-time is very low. Promptly save any work in progress, exit all open applications, and shut down the operating system. Battery Backup outputs are overloaded. Four Beeps Every 30 Seconds Continuous Beeping Continuous tone Chirps for 1 Minute every 5 hours Battery fails the automatic diagnostic test and should be replaced.
PAGE 6
Function Button Quick Reference Function UPS Status Description Power Power On 0.2 Off Press POWER to start receiving input utility power. If A/C input power is not available, the Back-UPS will run on battery power. Power Off 2 On The Back-UPS is not receiving input utility power, but is providing surge protection. 0.2 On Verify the status or condition of the Back-UPS. The LCD will illuminate for 60 seconds.
PAGE 7
Troubleshooting Problem Back-UPS will not switch on. Possible Cause The Back-UPS is not connected to utility power. The circuit breaker has been tripped. The internal battery is not connected. The utility input voltage is out of range. The Back-UPS does not provide Ensure that essential equipment is not power during a utility power plugged into a SURGE ONLY outlet. outage.
PAGE 8
Specifications Service VA 1300 VA / 1500 VA If the Back-UPS arrived damaged, notify the carrier. Maximum Load 780 W / 865 W Nominal Input Voltage 120 V Online Input Voltage Range 88 - 139V Automatic Voltage Regulation (94-107) +11.