Thank you for purchasing an DELANO product. DELANO WT-2 or YRS-1 will work as a timer and remote shutter release. Besides the full functions of shutter release, it also features multiply timer functions: delay timer, long exposure timer, interval timer and as well as setting for the number of exposure; its timing setting can be accurate to 0.1 seconds. The WT-2 or YRS-1 is great for time-lapse recording of blooming flowers, telephotography, etc.
Declaration of Conformity USA For WT-2 Product name: Wireless Timer Remote Shutter Release | Product name: Wireless Timer Remote Shutter Transmitter Release Receiver Trade name: DELANO Trade name: DELANO Model number: Model number: FCC ID: 2AEJW-WTR2 Manufacturer: Sheen Delano Technology Co., Manufacturer: Sheen Delano Technology Co., Ltd. Ltd. For YRS-1 Product name: Timer Remote Shutter Release Trade name: DELANO Model number: YRS-1 Manufacturer: Sheen Delano Technology Co., Ltd.
Parts Timer or YRS-1 1 — . Cable Port { J . Function LED . LCD Display . Sound / Mode Button . Back light / Lock Button Power Button . Play / Stop Button 8. Set Button 9. Adjustment buttons " a 10. Shutter Button 11. Battery Door \ J Receiver *Only works with . Cable Port . Function LED 8 Ee . Code Setting Button Ll Power Button 4 © 7 Cold Shoe Taf— Mounting Lug . Locking Ring 2 5 . Battery Door | w NOG AWN ENDGAME ON Shutter Release Cable 1. 2.5mm Input Plug 2.
2. When the sound function is enabled a musical symbol is visible on the LCD. 3. To disable sound press and hold the Sound/Mode Button until the sound symbol disappears. Using the Back light on or YRS-1 1. Use the Back light to illuminate the LCD screen. 2. Press and release the Back light / Lock Button, the back light will illuminate the LCD for approximately 10 seconds before turning off automatically. Using the Lock Button on or YRS-1 1. The Lock Button disabled all buttons.
DELAY LONG INTEL N BIN B-88-60. (EE) TIMER *The Wireless Signal Strength Indicator is not available on YRS-1's LCD. Changing modes on or YRS-1 Press the Sound/Mode Button to cycle between modes. A small indicator line will appear on the LCD over the selection. The modes are: S: Shutter Release. A half-press of the Stutter Button will focus, a full press will open the shutter. The LED on the Timer and Receiver will light green when focus is achieved. C: Continuous.
Setting the timer 1. Press the left or right Adjustment Buttons to select DELAY, LONG, INTEL, N, KILN. A small indicator line will appear on the LCD under the selection. 2. Press the Set Button to edit the time. 3. The up and down Adjustment Buttons will change the time. 4. The left and right Adjustment Buttons will move from hours, minutes, seconds, and part seconds. The left and right Adjustment Buttons will also move to the next or previous timer function.
Setting the Smart Code The frequency of transmitter and receiver will be per-set in production. You can use the timer instantly. To reset the smart code, please follow the procedures: 1. Turn on the transmitter and receiver. 2. Use a needle-like object to press into the code setting button on receiver, which will cause the LED on receiver to flash red and green light alternately for 25s. Press the shutter button on transmitter to reset the code during the code setting mode.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.