VEHICLE TRACKER Users Manual (ACT611) W CDM A VEHI CLE TRACKER Users Manual June, 2014 ACT611, V0.3 AnyDATA AnyTime AnyPlace Any Wireless Data Solutions™ All Rights Reserved.
VEHICLE TRACKER Users Manual (ACT611) AnyDATA WCDMA ACT611 Copyright © 2009 AnyDATA Corp. All Rights Reserved. Any part of this document may not be distributed, communicated, reproduced or transmitted in any form or by any means, electronic or mechanical or otherwise, for any purpose, without the permission of AnyDATA Corp. This document can be subjected to revision without further notice. Contact Address Headquarter AnyData Corporation 5 Oldfield, Irvine, CA 92618, http://www.anydata.
VEHICLE TRACKER Users Manual (ACT611) Contents Contents 3 Figures 3 Tables 3 1 Introduction 6 1.1 Purpose .................................................................................................................... 6 1.2 Technical Detail .................................................................................................. 6 1.3 Revision History ..................................................................................................
VEHICLE TRACKER Users Manual (ACT611) ! RF Exposure Warning: The radiated output power of this device is below the FCC radio frequency exposure limits. Nevertheless, the device should be used in such a manner that the potential for human contact during normal operation is minimized. In order to avoid the possibility of exceeding the FCC radio frequency exposure limit, human proximity to the antenna should not be less than 20 Cm. Information to user (FCC Part 15.
VEHICLE TRACKER Users Manual (ACT611) La puissance de sortie rayonnée de cet appareil est inférieure aux limites d'exposition de radio de fréquence IC. Néanmoins, le dispositif doit être utilisé de telle manière que le potentiel de contact humain pendant l'utilisation normale soit minimisé. Afin d'éviter la possibilité de dépasser la limite d'exposition de fréquence radio de la IC, la proximité humaine à l'antenne ne doit pas être inférieure à 20 cm. All Rights Reserved.
VEHICLE TRACKER Users Manual (ACT611) 1 INTRODUCTION 1.1 PURPOSE This manual discusses the purpose and usage of the Vehicle GPS Locator (ACT611). 1.2 TECHNICAL DETAIL Please refer to Technical Manual.pdf for a more detailed description of the ACT611. 1.3 REVISION HISTORY The revision history for this manual is shown in Table 1.1. Table 1.1: Revision History Version Date Description V 0.1 V 0.2 Initial Release – ACT611 Added French statements All Rights Reserved.
VEHICLE TRACKER Users Manual (ACT611) 2 PHYSICAL CONTENTS Figure 2.1: Package Contents The box should contain: • One ACT611 Vehicle GPS Tracker • One User Guide All Rights Reserved.
VEHICLE TRACKER Users Manual (ACT611) 3 DESCRIPTION: VEHICLE GPS LOCATOR (ACT611) 3.1 THE LATEST VEHICLE TRACKER IN GPS TECHNOLOGY Utilizing both assisted and standalone GPS, ACT611 is able to determine your location via a combination of cell triangulation and the greatest number of GPS satellites available. Alerts & Messages ACT611 has no button for user-set alert functions; the LBS (Location based server) can only know the device location and alerts including the vehicle information. 3.
VEHICLE TRACKER Users Manual (ACT611) Figure 3.1: External Interface All Rights Reserved.
VEHICLE TRACKER Users Manual (ACT611) 4 HANDING THE VEHICLE GPS LOCATOR 4.1 SET-UP 1. Most of vehicle has an OBD-II (On Board Diagnostics) connector, which is located within 2 feet of the steering wheel. 2. The installation is very easy, just put the ACT611 to the OBD-II connector in user vehicle. 3. The ACT611 will power on automatically from vehicle battery and start initiation for WCDMA network access. 4. After install of device to vehicle, all services are served by server. Figure 4.
VEHICLE TRACKER Users Manual (ACT611) 5 POWERING ON/OFF THE VEHICLE GPS LOCATOR 5.1 POWERING ON/OFF To Power ON: 1. Insert the device to OBD-II connector. 2. Then, the device has automatically powered on according to vehicle condition. 3. There is no visual way to confirm whether device has power-on or not. 4. But, user can make sure the location from web-server, or application. To Power OFF: 1. If the device is needed for totally power-off, then just remove it from the OBD-II connector. 2.
VEHICLE TRACKER Users Manual (ACT611) 6 VEHICLE GPS LOCATOR SPECIFICATIONS 6.1 FORM FACTOR • Dimensions : 80 x 45 mm, 22mm in Height • Weight 66.5g 6.2 HARDWARE SPECIFICATIONS • Assisted & Standalone GPS • Operating Voltage 9 ~ 18V, (internally 3.5V for WCDMA RF) • Max Output Power 0.3W • Current Consumption Idle mode (50mA @ 12V) • Light Sleep Mode (20mA @ 12V) • Deep Sleep Mode (4mA @ 12V) • Sensitivity Less than -104dBm • Receive Frequency 1930 ~ 1990MHz for B2, 869 ~ 894MHz for B5.
VEHICLE TRACKER Users Manual (ACT611) 7 LIMITATIONS AnyDATA OF LIABILITY expressly interruption, assumes deletion, no responsibility defect, delay in for any operation error, or omission, transmission, communications failure, theft or destruction or unauthorized access to, or alteration of, any use of the AnyDATA Locating Service through the Internet or other communication services.