HDTV INDOOR ULTRATHIN ANTENNA AMPLIFIED z OMNIDIRECTIONAL 1500080 User’s Guide Please read this user’s guide before using your new antenna.
Package Contents Antenna Power Injector 6-ft Coaxial Cable User’s Guide AC Adapter Detachable Stand Features • Up to 20-mile range, ideal for urban use • Sleek, unobtrusive design • Integrated low-noise amplification • Omnidirectional • Sits upright, lies flat, or mounts to a wall • Cable management system conveniently stores the wires out of sight • Supports analog or digital signals 2
Connect Antenna 1. Connect one end of the included 6-ft coaxial cable to the antenna’s output cable. 2. Connect the other end of the cable to the power injector’s ANT terminal. 3. Connect the power injector’s pre-attached coaxial cable to the Antenna In jack on your TV, receiver, or set top box. 4. Connect the AC adapter to the power injector, and plug the AC adapter into a standard outlet. 5. Adjust the antenna to a position that provides the best reception.
Å È To Power Injector’s DC 9V Jack TV Ç OR Receiver To Antenna In OR Set Top Box 4 Æ
On a Wall: 1. Drill two holes into the wall at the distance that fits the antenna mounting holes, about 4¾ inches (120 mm) apart. 2. Thread screws (not supplied) into each hole with the heads extend about ¼ inch (6 mm) from the wall. 3. Place the antenna mounting holes over the screws. On a Flat Surface: Lay the antenna flat, with the rubber feet down, on a flat surface for multi-direction reception.
nNote: • For HD reception, you need a TV with an ATSC HDTV tuner, an HDTV receiver, or digital set top box. • Use only an adapter that supplies 9VDC and delivers at least 300mA. Its center tip must be set to positive and its plug must fit the power injectors DC 9V jack. • You can purchase a coaxial extension cable up to six feet long to extend the antenna distance from your TV or receiver. Specifications Power Source Antenna ...................................................................
No Channels? In most cases, simply connecting your antenna to your TV will not instantly provide your local channels. Most televisions require some minor configuration before you see programming. Refer to your television’s user’s guide for information No Channels about performing the following steps: 1. Set your television to “Over the Air” or “Antenna” reception. 2. Perform a search for channels.
FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Ignition L.P. will, at its option, unless otherwise provided by law: (a) repair the product without charge for parts and labor; (b) replace the product with the same or a comparable product; or (c) refund the purchase price. All replaced parts and products, and products on which a refund is made, become the property of Ignition L.P. New or reconditioned parts and products may be used in the performance of warranty service.