Installation Instructions

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure
requirement. in portable exposure condition without restriction.
ISED statement
English:
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions: (1) This device may not
cause interference. (2) This device must accept any
interference, including interference that may cause undesired
operation of the device.
French: Cet appareil contient des émetteurs/récepteurs
exempts de licence qui sont conformes aux RSS exemptés de
licence d'Innovation, Sciences et Développement économique
Canada. L'exploitation est soumise aux deux conditions
suivantes : (1) Cet appareil ne doit pas provoquer
d'interférences. (2) Cet appareil doit accepter toute interférence,
y compris les interférences susceptibles de provoquer un
fonctionnement indésirable de l'appareil.
This device meets the exemption from the routine evaluation
limits in section 2.5 of RSS 102 and compliance with RSS 102
RF exposure, users can obtain Canadian information on RF
exposure and compliance.
cet appareil est conforme à l'exemption des limites d'évaluation
courante dans la section 2.5 du cnr - 102 et conformité avec rss
102 de l'exposition aux rf, les utilisateurs peuvent obtenir des
données canadiennes sur l'exposition aux champs rf et la
conformité.
This equipment complies with Canada radiation exposure limits
set forth for an uncontrolled environment.
Cet équipement est conforme aux limites d'expositionaux
rayonnements du Canada établies pour un environnement non
contrôlé.
The device has been evaluated to meet general RF exposure
requirement. This equipment should be installed and operated
with minimum distance 0mm between the radiator & your body.
L'appareil a été évalué pour répondre aux exigences générales
d'exposition aux RF. Cet équipement doit être installé et utilisé
avec une distance minimale de 0 mm entre le radiateur et votre
corps.