Product name: Wireless Solution Trade name: RF iLink Model no.
MiniOS User Manual V1.3.
The default setting for User Name and Password are admin and password. The default IP is 10.10.10.
System>Basic Setting User can change the device name enable or disable VLAN, and obtain current position from GPS.
System>IP Settings The current IP Address is set to 10.10.10.11. Or just get the IP address from DHCP Server.
System>DHCP Settings Currently this device is set to Base Station and obtains the IP from another DHCH Server; The DHCP Server for this device was in disable status.
System>Time Settings
1. Base Station: Beacon Interval lime (40-1000} Maximum Association Stations (1-128} Frame Schedule Policy 巨三二 因as possible . Broadcast Wireless Network Name 可 Wireless Network Name 三tion 匝 巨 匠 ms . Operating Mode 41 Wireless Bridge Parameters 寸 The SSID for this Wireless Network is "Wireless" and the SSID is set in Broadcast enable status. Channel/ Frequency 丨20MHz 丨5755.
1.
1.2 Wireless 1 > Access Control Add or delete Allow or delete MAC Address.
2. CPE: (Customer Premise Equipment) is either to connect a Base Station or Bridge AP Radio mode. (Ex.
Read the following instructions to make a Point to Point AP Bridge connection. 3 Point 1 (Point-to-Point) Type the remote site MAC Address 3.
Read the following instructions to make a MESH (Peer to Peer) connection. 1.
2.
You also can enable both Wireless 1 and Wireless 2 Mesh Ports See the information Restore to default settings: Go to Management > Backup/Restore
The system will take about 40 seconds to restore factory default settings
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
「低功率電波輻射性電機管理辦法」 低功率電波輻射性電機管理辦法」第十二條: 第十二條: 經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自 變更頻率、加大功率或變更原設計之特性及功能。 「低功率電波輻射性電機管理辦法」 低功率電波輻射性電機管理辦法」第十四條: 第十四條: 低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象 時,應立即停用,並改善至無干擾時方得繼續使用。 前項合法通信,指依電信法規定作業之無線電通信。 低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干 擾。 應避免影響附近雷達系統之操作。 高增益指向性天線只得應用於固定式點對點系統。
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.