User's Manual

RF Wireless Transmitter

Instructions Manual

Thank you for purchasing the new generation RF Wireless Thermometer. Designed and

engineered with the state-of-art technology and components, this instrument will

provide accurate and convenient measurement of indoor and outdoor temperatures.

Read this manual carefully to full explore the features and functions of the new

product.

Name and Functions of Buttons:

CH Select Channel 1,2 & 3 of the transmitter.

C/F C/ F selection

Tx Trigger manual transmittion

BATTERY INSTALLATION

Lift off the bracket stand, loose the 2 screws with a small screwdriver.

Select channel for each transmitter, and then insert 2 pcs AA batteries according

to the polarity indicated.

After selecting the desired setting, replace the cover and tighten the 2 screws.

SETTING UP THE WIRELESS CONNECTION:

•

For the first installation, always insert batteries to the home unit and then

the remote sensor. The flash of outdoor temperature on the home unit means

the seeking the connection with the transmittor. Install batteries of

transmitter in this moment for registration.

•

Always set the first sensor to CH 1. Maximum three sensors can be registered.

•

To verify transmission, press the Tx button of the remote sensor. The red LED

on the remote sensor will flash when it transmit a signal. Temperature of the

remote sensor will be updated and displayed on the remote sensor.

•

When replacing batteries for the remote sensor, remember to clear the

corresponding channel of the home unit in this way: Select the respective

channel by pressing the CHANNEL button on home unit, then hold the CHANNEL

button 3 seconds to clear the registration.

LOW BATTERY INDICATION

Low battery indication is available for the transmitters. When the low battery

indicator is shown on the display of transmitter or the outdoor display of the

home unit, replace the batteries of the corresponding transmitter and follow the

setup procedure as mentioned in this instruction manual.

SPECIFICATIONS

Range of temperature measurement:

-20 C to 60 C (14F to 158F),

lowest -50 C (-58F) using extension cord

Transmission : Max. 30M (100 ft.) open area, RF434 MHz

Resolution : 0.1 degree for temperature

Battery life : 1 year (alkaline batteries recommended)

PAGE 1
RF Wireless Transmitter Instructions Manual Thank you for purchasing the new generation RF Wireless Thermometer. Designed and engineered with the state-of-art technology and components, this instrument will provide accurate and convenient measurement of indoor and outdoor temperatures. Read this manual carefully to full explore the features and functions of the new product. Name and Functions of Buttons: CH Select Channel 1,2 & 3 of the transmitter.
PAGE 2
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.