User's Manual

DIGITAL THERMO SENSOR OWNER'S MANUAL

Thank you for purchasing the new generation electronic thermo sensor. Designed and

engineered with the state-of-art technology and components, this instrument will provide

accurate and reliable measurement of outdoor temperature and humidity, and a 433MHz RF

communication with your weather station. Read this manual carefully to full explore the

features and functions of the new product.

Name and Functions of Switch and Buttons:

CH Select Channel 1,2,3

TX Force transmission of RF signal

MODE Change display between temperature, humidity or auto scroll

C/F Select the reading between C and F

BATTERY INSTALLATION

Lift off the bracket stand, loose the 4 screws with a small screwdriver, insert 2 pcs AAA

batteries according to the polarity indicated. Replace the cover and tighten the 4 screws.

SETTING UP THE WIRELESS THERMOMETER:

• For the first installation, always insert batteries to the home unit and then the remote

sensor.

• Set Channel 1 for the first remote sensor. Set channel 2 and channel 3 for the additional

2nd and 3rd sensors.

• Press the Tx button on the back of remote sensor to verify the RF reception.

C/ F SELECTION

Press “C/F“ to select degree C/ degree F on the LCD display.

LOW BATTERY INDICATION

Low battery indication is available for the remote sensors. Replace the batteries and follow the

setup procedure as mentioned in this instruction manual.

BATERY DISPOSAL

Replace only with the same or equivalent type recommended by the manufacturer.

Please disposal of old, defective batteries in an environmentally friendly manner in

accordance with the relevant legislation.

FCC DISCLAIMER

FCC ID: L5C0781TX-H

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

SPECIFICATIONS

Range of temperature measurement:

Remote sensor : -20 C to +60 C (-4 F to +140 F)

Channel : 3

Transmission : up to 30M (100 ft.) open area, RF434 MHz

Resolution : 0.1 degree for temperature, 1% for humidity

Batteries : AAA x 2 pcs

PAGE 1
DIGITAL THERMO SENSOR OWNER'S MANUAL Thank you for purchasing the new generation electronic thermo sensor. Designed and engineered with the state-of-art technology and components, this instrument will provide accurate and reliable measurement of outdoor temperature and humidity, and a 433MHz RF communication with your weather station. Read this manual carefully to full explore the features and functions of the new product.
PAGE 2
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.