ROYAL ® WS10 thermometer OPERATIONAL MANUAL OUT
WS 10 INSTRUCTION MANUAL Congratulations on purchasing the Royal WS 10 Thermosolutions Thermometer. This model features Indoor Temperature and Outside Temperature. Outside Temperature is provided with the 434 MHz cable free temperature sensor. No wire installation is required. For additional convenience, a magnetic backing has been used for placement on kitchen refrigerators. Please read all the instructions to ensure understanding of the features. The WS 10 uses a liquid crystal display.
INSTALLATION OF THE BATTERY IN THE REMOTE UNIT The remote unit uses AA x 2 batteries. To install or replace the batteries, please follow these steps: Fig.3 * Unscrew the screw on the back of the compartment and remove the cover. * Insert the batteries, observing the correct polarity. * Replace the battery cover on unit and seal by re-screwing tightly. It is recommended replacing the batteries in both units on an annual basis to ensure optimum accuracy.
SETTING UP 1. Once the batteries have been placed in the Remote unit, they will start transmitting temperature readings in 30 seconds. By depressing the side Test button on the Remote unit (Fig. 2A), the signal to the base unit will immediately update the outside temperature. The LED on the remote unit will illuminate after depressing the Test button. This indicates the signal is being sent. The Remote will sense the temperature change every 30 seconds. When there is a +/– 0.
OUTDOOR TEMPERATURE * Press and release the Toggle Button * The OUT indicator and Antenna Icon will illuminate * If the Antenna Icon does not illuminate or if dashes "-" appear, the WS 10 has not received an update within the last hour from the remote unit. First press the Toggle Button twice to update the Outdoor Temperature. Next check the remote batteries and refer to the Setting Up and 434 MHz sections of this manual. INDOOR TEMPERATURE * Press and release the Toggle Button.
STANDARD WARRANTY OLIVETTI OFFICE USA, Inc. d/b/a ROYAL CONSUMER INFORMATION PRODUCTS, 379 Campus Drive Somerset, NJ 08875 WARRANTS that your NEW Royal product is free of defects of workmanship and materials. If there is a defect or malfunction of this product, Royal will repair it free of charge as follows: PARTS: New or comparable rebuilt parts in exchange for defective parts for ONE YEAR from date of customer purchase. LABOR: Royal provides labor warranty for NINETY DAYS from date of end-user purchase.
TO OBTAIN SERVICE UNDER THE TERMS OF THIS WARRANTY: In the event you are unable to obtain a replacement product from your retailer, please do the following: 1. Send a copy of your original sales receipt showing original purchase date along with your mailing address and a note describing the nature of the problem to: Royal Consumer Warranty Processing PO Box 161 Jamison, PA 18929-0161 Do Not Return the Product to This Address! 2.
WS10 thermometer INSTRUCTION TO THE USER Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
