User's Manual

1 01 02 03

USER MANUAL

ANKERBOX

Getting Started

① Plug one end of the AC adapter into the power port,

and the other end into the power outlet.

② Tie up the power cable and ﬁx it.

③ Press the AC power button to power on the AnkerBox.

Wi-Fi Settings

① Download USR Simplecoﬁg App from the App Store

(iOS devices running 10.0 and later versions).

② Open the app and choose Conﬁgure New Device.

Select the AP you want to conﬁgure, and connect.

③ Follow the onscreen instructions to ﬁnish the Wi-Fi

setup.

QR code

backlight

O

Wi-Fi or 4G network

disconnected

Solid white

Connected to Wi-Fi / 4G

network

Loading the Ankerbox with PowerBank

① Press Return button on the AnkerBox.

The corresponding LED indicator ﬂashes green.

② Insert the PowerBank into the slot with an indicator

that ﬂashes green.

③ Repeat the steps above to insert the PowerBank

batteries into all the slots.

Using the AnkerBox

Rent a Battery

① Scan the QR code to rent a battery. A battery will

pop out, and the corresponding LED indicator will

ﬂash green.

② Take the battery away. The LED indicator will go o.

Product Number: A2850

5100500XXXX V01

PAGE 1
Getting Started Wi-Fi Settings ① Plug one end of the AC adapter into the power port, and the other end into the power outlet. ① Download USR Simplecofig App from the App Store (iOS devices running 10.0 and later versions). ② Open the app and choose Configure New Device. Select the AP you want to configure, and connect. ③ Follow the onscreen instructions to finish the Wi-Fi setup.
PAGE 2
Indicator Slot indicator Status All flash red • AnkerBox exceeds the rated temperature When using this product, basic precautions should always be followed, including the following: • AnkerBox self-test fails 1) • Over 3 malfunctions occur in the battery slot 2) Do not store the product in hot or humid environment, especially not expose it to rain or snow or extremely low air pressure.