User Manual

Model:SM-608AG
The RF2.4GHz optical mouse use 3.7V LI-ion batteries.
Trun on swith “ON” position
Nano receiver
* This mouse is equipped with Traveling-Power-Save function.
When you are traveling with this mouse, the LED of the mouse will be switched off
automatically for the purpose of power-save, but the pre-condition is that the
receiver is disconnected with your notebook or PC.
* when your mouse no any clik or scroll or moving, the mouse will come to sleep
state for the economize after about 8 minutes, for the wake up, you can click any
button for this
Your optical 6 button mouse is provide 800&1200&1600 dpi switch.
1:when you want use the mouse ,you can take out the receiver to computer by the
list step;
2:when you need stop the work or to travel, you can store the receiver on the mouse
for the moving by the list step.
DPI Switch
1.Connect the USB plug nano to USB port of the computer
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving an tenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Trun on swith