Installation Instructions

INSTRUCTIONS
0911-05
Titus Wireless Charging
Rellable Journalbook
OUTSIDE
BACK FRONT
INSIDE FRONT INSIDE FOLD-IN
FOLD-IN
INSIDE BACK
INSIDE
FOLD
FOLD
IM_0911-05
04.18.2019
WHITE, FOLDED CARD PRINTED IN BLACK AND WHITE - 3.5” X 2” (FOLDED)
2.000"
50.800 mm
3.500"
88.900 mm
3.500"
88.900 mm
3.500"
88.900 mm
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment , This equipment shall be installed
and oprated with minimum distance 20cm between the radiator & body
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
FCC ID:2ANFN0911-05

Summary of content (1 pages)