Product Instruction

Table Of Contents

Atomizing sterilizer instructions

Thank you for buying our products

Please read the product instruction carefully before use

Please use correctly and safely

Specific operation

1. Please open the package to confirm the product and its accessories

Match the lower shell with the base, and rotate clockwise to lock it

3. Turn the handle screw into position

4. Match the upper shell with the lower shell, and lock it by clockwise rotation

5. Put the product in a flat position and power it on

6. Open the lid and add 5L water from the top

7. After adding water, use tweezers to add special tablets for disinfection from

above

8. Connect the power adapter and power it on

9. The voltage shall be 100V~240V(50Hz/ 60Hz)

10.Touch the power switch to turn on the product

Cleaning and maintenance

1. Before cleaning, be sure to cut off the power and unplug the power plug

2. In order to avoid discoloration, thinner, toluene, acid detergent, kerosene,

PAGE 1
Atomizing sterilizer instructions Thank you for buying our products Please read the product instruction carefully before use Please use correctly and safely Specific operation 1. Please open the package to confirm the product and its accessories 2. Match the lower shell with the base, and rotate clockwise to lock it 3. Turn the handle screw into position 4. Match the upper shell with the lower shell, and lock it by clockwise rotation 5. Put the product in a flat position and power it on 6.
PAGE 2
alcohol, and do not use chemical rags to wipe them. 3. When not in use for a long time, please clean the body, put it in the original packing box after drying, and keep it in a place without moisture. When drying is insufficient, corrosion or failure will lead to rust 4. When cleaning the water in the lower part, take the upper part away 5. When cleaning the atomizing tablet, please wipe it gently with a brush or cotton swab 6.
PAGE 3
FCC ID: 2AXMKJG-PL5000 FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.