User's Manual

ManualsBrandsAndrew Wireless System ManualsElectronicsOptical ION-M Remote Unit for cellular systems

Installation Instruction

The Remote Unit, Extension Unit or Master Unit has to be

mounted by proffessionel / special trained installer.

1.1. MECHANICAL INSTALLATION

1.1.1. General

Read the health and safety warnings in section 1.3.

1. Do not install the unit in a way or at a place where the specifications outlined in the Environmental

and Safety Specifications leaflet of the supplier are not met.

2. It is recommended to use the mounting hardware delivered by the supplier only. If different

mounting hardware is used, the specifications for stationary use of the Remote Unit must not be

exceeded.

 Note: Exceeding the specified load limits may cause the loss of warranty!

3. The unit is considerably heavy. Make sure that a suitable mounting surface is used. Ensure there is

adequate manpower to handle the weight of the system.

4. Due to power dissipation, the Remote Unit may reach a very high temperature. Ensure sufficient

airflow for ventilation.

5. When connecting and mounting the cables (RF, optical, mains, ...) ensure that no water can penetrate

into the unit through these cables.

6. Also observe all additional rules or restrictions regarding mounting that depend on the type of

Remote Unit. For details refer to section 7.2.2 Mechanical Specification. Install the unit vertically

with the fan unit at the top. A maximum tilt angle of 25° from a vertical position must be kept, as in

the following illustrations:

Summary of content (6 pages)

PAGE 1
Installation Instruction The Remote Unit, Extension Unit or Master Unit has to be mounted by proffessionel / special trained installer. 1.1. MECHANICAL INSTALLATION 1.1.1. General Read the health and safety warnings in section 1.3. 1. Do not install the unit in a way or at a place where the specifications outlined in the Environmental and Safety Specifications leaflet of the supplier are not met. 2. It is recommended to use the mounting hardware delivered by the supplier only.
PAGE 2
7. A spacing of 40 mm (1.58 inch) around the unit is required. 8. To ensure sufficient airflow when mounting the unit in enclosed spaces, two lid openings (one for the air inlet and the other for the air outlet) have to be provided. Do not block these air inlets and outlets when mounting the Remote Unit. The size of each opening must equal at least 12 x 12 cm (144 cm2). Make sure, too, there is no thermal short circuit between the air inlet and air outlet.
PAGE 3
1.2. ELECTRICAL INSTALLATION 1.2.1. General Read the health and safety warnings in section 1.3. 1. This unit contains dangerous voltages. Loss of life, severe personal injury, or property damage can be the result if the instructions contained in this manual are not followed. 2. It is compulsory to ground (earth) the unit before connecting the power supply. A grounding bolt is provided on the cabinet to connect the ground-bonding cable. 3.
PAGE 4
 Note: The electrical installation has to be performed in accordance with the safety regulations of the local authorities. Due to safety reasons, the electrical installation must be performed by qualified personnel only. The repeater must not be opened. The maximum antenna height has to be 10 meters above ground. 1.3. HEALTH AND SAFETY WARNINGS 1.
PAGE 5
8. Note for a Class A digital device or peripheral: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
PAGE 6
Equipment Symbols Used Please observe the meanings of the following symbols used in our equipment: Symbol Compliance Meaning --- Alert sign to R&TTE Symbol Indicates conformity with the R&TTE directive 1999/5/EC certified by the notified body no. 0700.