User's Manual

ManualsBrandsAndrew Corporation, Base Station Subsystems Group ManualsElectronicsRemote Radio Head RRH 2x40W 700MHz RF101002

Key Specifications:

Base-Station Interface: CPRI High Speed Digital I/O (Cellular LTE Traffic + Control)

2 Duplexed Antenna Ports:

Tx Frequency Range: 728-746MHz; 40WRF(+46.0dBm) max each port;

Rx Frequency Range: 698-716MHz; sensitivity -101.5dBm(10MHz LTE)

Power Input: -48VDC nominal; Load Current 7.4 ADC (with 2x40WRF)

2x40W RRH-700-L1 for E-UTRAN Band 13 ( FCC ID:S8L-RRH700L1)

Product Description

Summary of content (5 pages)

PAGE 1
2x40W RRH-700-L1 for E-UTRAN Band 13 ( FCC ID:S8L-RRH700L1) Product Description Key Specifications: Base-Station Interface: CPRI High Speed Digital I/O (Cellular LTE Traffic + Control) 2 Duplexed Antenna Ports: Tx Frequency Range: 728-746MHz; 40WRF(+46.0dBm) max each port; Rx Frequency Range: 698-716MHz; sensitivity -101.5dBm(10MHz LTE) Power Input: -48VDC nominal; Load Current 7.
PAGE 2
Functional Block Diagram 2 x 40W 700MHz RRH-see another file
PAGE 3
2x40W 700MHz RRH-700L1 – Interface Ports 8) External Alarms 1-3 9) External Alarms 4-6 7) Antenna Line Device Port: Input/Output. RS485 signaling +12V/1.0A; +24V/0.85A 10) Tx1 Monitor Port: Output. -40dBc sample of RF on Tx1/Rx1 port 12) Auxiliary Rx1 Port 13) Auxiliary Rx2 Port Input/Output. Bypass internal LNA or Feed additional external Receivers from here. 5) DC Power Port: Input. -48V (-38.5V to 58V) With Tx1=Tx2=40W, 7A 2.2A after boot-up 3.0A bias ON, no RF 11) Tx2 Monitor Port: Output.
PAGE 4
2x40W 700MHz RRH-700L1 – Maintenance Panel Reset Switch Serial RS232 Connection JTAG DSP 14) Ethernet Maintenance Port: Input/Output 10/100 Base-T Status LED
PAGE 5
FCC Statement/ FCC ID: S8L-RRH700L1 This device complies with Part 2, 15 and 27 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning Changes of modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.