User's Manual

ManualsBrandsAndrew Corporation, Base Station Subsystems Group ManualsElectronicsRRH 2x45W 1900MHz AA190045 RF151032

2x45W RRH for E-UTRAN Band 25 (FCC ID: S8L-AA190045)

Product Description

Key Specifications:

Base-Station Interface: CPRI High Speed Digital I/O (PCS LTE Traffic + Control)

2 Duplexed Antenna Ports:

Tx Frequency Range: 1930-1995MHz; 45WRF (+46.5dBm) max each port;

Rx Frequency Range: 1850-1915MHz; sensitivity -101.5 dBm (10MHz LTE)

And 2 RX Ports:

Rx Frequency Range: 1850-1915MHz; sensitivity -101.5 dBm (10MHz LTE)

Power Input: -48VDC nominal; Load Current 8.4 ADC (with 2x45WRF)

Summary of content (4 pages)

PAGE 1
2x45W RRH for E-UTRAN Band 25 (FCC ID: S8L-AA190045) Product Description Key Specifications: Base-Station Interface: CPRI High Speed Digital I/O (PCS LTE Traffic + Control) 2 Duplexed Antenna Ports: Tx Frequency Range: 1930-1995MHz; 45WRF (+46.5dBm) max each port; Rx Frequency Range: 1850-1915MHz; sensitivity -101.5 dBm (10MHz LTE) And 2 RX Ports: Rx Frequency Range: 1850-1915MHz; sensitivity -101.5 dBm (10MHz LTE) Power Input: -48VDC nominal; Load Current 8.
PAGE 2
x45W 1900MHz RRH – Interface Ports (Bottom) 1) External alarms port 8) DC Power Port: Input. -48V (-38.5V to 58V) With Tx1=Tx2=45W, 8A 2.2A after boot-up 3.0A bias ON, no RF 2) Secondary CRPI Port Serial Digital Traffic & Control Input/Output. (accepts optical or electrical SFP modules) Supported Data rates: Rate 2: 1.2288Gbps Rate 3: 2.457.6Gbps Rate 4: 3.
PAGE 3
2x45W 1900MHz RRH – Interface Ports (Top) 9) Rx4 Port: Up-link RF In: 1850-1915MHz; -102dBm to -40dBm 13) Tx2/Rx2 Port: Duplexed Antenna Ports Input/Output. Down-link RF Out: 1930-1995MHz; +46.5 dBm (45W each) Up-link RF In: 1850-1915MHz; -102dBm to -40dBm 10) AISG Port Input/Output, RS485 signaling +24VDC/2A 11) Rx3 Port: Up-link RF In: 1850-1915MHz; -102dBm to -40dBm 12) Tx1/Rx1 Port: Duplexed Antenna Ports Input/Output. Down-link RF Out: 1930-1995MHz; +46.
PAGE 4
FCC Statement/ FCC ID: S8L-AA190045 This device complies with Part 2, 15 and 24 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning Changes of modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.