Assembly Manual SJ:>INSTANO COMPONENT 6: RECORD RACK C9 □ nd □ ver www.andoveraudio.
Table of Contents lntroduction .......................................................4 In the Box.......................................................... 5 Assembly ........................................................6-9 Anti-Tip Kit. ........................................................10 Warranty and Service.........................................................
Introduction We're really pleased that you have chosen Spinstand. Spinstand is perfectly matched to Spinbase, but may also be used with the Andover Model-One, or any audio component smaller than 18" x 13.5" on the top shelf. It will provide a solid and stable platform suitable for vinyl record playback. Spinstand will acommodate up to approximately 150 records on its two lower Melamine shelves.
In The Box ..
Assembly 1. Locate the Top Shelf (Item 1) and place it top-down on a soft surface. The holes in the corners of the shelf are closer to the back edge than to the front edge. Orient the top shelf so that the wider border (Front) is towards you. 2. Install the Headphone Hanger (Item 13) using the two screws (Item 14). Align the Headphone hanger with the pilot holes corresponding to the side of the stand you prefer to hang your headphones. You may omit this step if you don't need the hanger. 3.
Assembly - Cont. ~ Longer threads / Shorter threads 9. Attach a coupler (Item 8) to each of the four threaded rods 10. The Long Rods (Item 17) have longer thread length on on end than on the other. Attach the end of a Long Rod with the shorter thread length to each of the couplers. Tighten firmly by hand. 11. Slide a Long Pillar (Item 6) over each rod assembly and carefully align the pillar in the square recess cut in the shelf.
Assembly - Cont. 6 12. Slide the Middle Shelf (Item 3) over the threaded rods making sure the edge with the wider spacing between the holes and edge is towards the front, just as you did with the Top Shelf. The shelf should be oriended with the top down. The Record Stop should be facing down and along the back. 13. Slide the remaining Long Pillars (Item 6) over each rod assembly and carefully align each pillar in the square recess cut in the shelf. 14.
Assembly - Cont. 18 18. Turn the completed stand upright. Insert the four Top Plugs (Item 18) into the four corner holes to conceal the hardware. 19. Place the Spinstand into position. Adjust the feet to assure that the stand is level and stable.
Anti-Tip Kit installation IMPORTANT NOTE: An Anti-Tip Strap is included with your Spinstand. Please use it whenever Spinstand is installed in a location where it may tip and cause physical harm. Drywall inserts {Item 23) and screws {Item 22) are included with this kit, but may not be suitable for every type of wall. It is your responsibility to supply wall mounting hardware suitable for the specific wall construction of your home.
Two-Year Limited Warranty Andover Audio warrants your product against manufacturing defects and workmanship to the initial purchaser for a period of two (2) years from the date of delivery to customer. Andover Audio will repair or replace the unit as necessary to restore proper operation. This warranty covers both parts and labor for the warranty period. The warranty excludes physical damage caused by accident or abuse outside of our control, or if the unit is damaged due to incorrect packing.
Andover Audio, L.L.C. 15 High Street North Andover, Massachusetts 01845 www.andoveraudio.com I support@andoveraudio.com 1978.775.3670 Andover is a trademark of Andover Audio L.L.C. Andover Audio subscribes to a program of continuous improvement. As a result, some product features and characteristics may change Without prior notice.