Installation & Assembly

W
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ
AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Installation steps
Turn off the power at fuse or circuit box.
1. Thread two headless screws (E) through the
cross bar (A), and then secure them with four
lock nuts (F) (two on each side of the cross
bar (A).) Adjust the length of the headless
screws (E) if necessary.
Note: Make sure the headless screws are lined up
horizontally to make the fixture level.
2. Attach the cross bar (A) to the outlet box by using two
mounting screws (B).
Green Grounding Screw (D)
Headless screw (E)
Mounting Screw (B) Wire Connector (C)
Lock Nut (F) Bolt Nut (G) Rubber Pad (H)
Cross Bar (A)
Max.60W Type A Bulb
(not included)
Glass Shade
Fixture
Set Screw
Metal Cover
Backplate
Photocell
Bolt Nut (G)
Rubber Pad (H)
Wire Connector (C)
House Grounding Wire
Outlet Box
Mounting Screw (B)
Green Grounding Screw (D)
Headless Screw (E)
Cross Bar (A)
Lock Nut (F)
Fixture Grounding Wire
Fixture Wire