User's Manual

ManualsBrandsAndersen ManualsElectronicsIntrusion Detector-400-DH Sensor

9142195 BA-0 1 Revised 03/09/16

VeriLock

Security Sensor Application

VeriLock

Security Sensor Application

▶ Read guide from beginning to end before starting installation. Read all warnings and cautions during unit installation.

Lea completamente la guía antes de comenzar la instalación. Lea y respete todas las advertencias y precauciones durante la instalación de la unidad.

▶ Check with your local building code ofcial to identify and conrm compliance with local building code requirements.

Consulte los códigos locales de construcción para identicar y conrmar que se cumplan los requisitos del código de construcción.

Thank you for choosing Andersen. / Gracias por elegir Andersen.

For questions call 1-888-888-7020. For more information and/or guides visit andersenwindows.com.

Please leave this guide with building owner.

Si tiene alguna pregunta llame al 1-888-888-7020. Para obtener más información y/o guías, visite andersenwindows.com.

Deje esta guía con el dueño de la construcción.

for Andersen

A-Series Double-Hung Windows

for Andersen

A-Series Double-Hung Windows

Parts Included / Partes Incluidas

(1) VeriLock Sensor / VeriLock Sensor

(4) VeriLock Active Cover / VeriLock Active Cover

(4) Lock Magnet / Lock Magnet

(1) Keeper Magnet / Keeper Magnet

(1) CR-2025 Battery / CR-2025 Battery

(1) Battery Cap / Battery Cap

(8) #8 x 1" Screw (color matched) /

#8 x 1" Screw (color matched)

(1) Cleaning Wipe / Cleaning Wipe

Tools Needed / Herramientas Necesarias

∙ Safety Glasses / Lentes de seguridad

∙ Phillips Screwdriver /Destornillador Phillips

Use caution when working at elevated heights and around unit openings.

Follow manufacturers’ instructions for ladders and/or scaffolding. Failure

to do so may result in injury or death.

Sea cauteloso al trabajar en lugares elevados y cerca de las aberturas de

la unidad. Siga las instrucciones del fabricante para el uso de escaleras

y/o andamios. Si no lo hiciera, podrían producirse lesiones o la muerte.

Follow manufacturers’ instructions for hand or power tools. Always

wear safety glasses. Failure to do so may result in injury and/or

product damage.

Siga las instrucciones del fabricante para el uso de herramientas

eléctricas o manuales. Utilice siempre gafas de seguridad. Si no lo

hiciera, podrían producirse lesiones y/o daños al producto.

VeriLock Sensor

VeriLock® Active Cover

CR-2025

Battery

CR-2025

Battery

Battery Cap

Keeper Magnet

Lock Magnet

Additional Parts Required for Units with Two Locks

(4) VeriLock Dummy Cover /

VeriLock Dummy Cover

(8) #8 x 1" Screw (color matched) /

#8 x 1" Screw (color matched)

#8 x 1" Screw

Tornillo No. 8 x 1"

VeriLock® Dummy Cover

#8 x 1" Screw

Tornillo No. 8 x 1"

NOTE: VeriLock dummy

cover is installed on the

left lock of units with two

locks, as viewed from the

interior.

NOTE: VeriLock dummy

cover is installed on the

left lock of units with two

locks, as viewed from the

interior.

Summary of content (6 pages)

PAGE 1
VeriLock® Security Sensor Application VeriLock® Security Sensor Application for Andersen® A-Series Double-Hung Windows for Andersen® A-Series Double-Hung Windows Thank you for choosing Andersen. / Gracias por elegir Andersen. For questions call 1-888-888-7020. For more information and/or guides visit andersenwindows.com. Please leave this guide with building owner. Si tiene alguna pregunta llame al 1-888-888-7020. Para obtener más información y/o guías, visite andersenwindows.com.
PAGE 2
Batteries carry the risk of fire, explosion and burns. Do not recharge, disassemble, heat above 212 degrees F (100 degrees C) or incinerate. Dispose of used batteries promptly and properly. Keep away from children. Les piles représentent un risque d’incendie, d’explosion et de brûlures. Ne pas recharger, démonter, chauffer à une température excédant 100 degrés C (212 degrés F) ou incinérer. Éliminer les piles rapidement et de manière appropriée. Garder à l’écart des enfants.
PAGE 3
4 5 Interior Interior Phillips Screwdriver Destornillador Phillips Lock Cerrojo Unlock and open bottom sash. Desbloquee y abra la hoja inferior. 6 Interior NOTE: VeriLock sensor is installed on the right lock of units with two locks, as viewed from the interior. NOTE: VeriLock sensor is installed on the right lock of units with two locks, as viewed from the interior. Remove screws from lock and dispose of properly. Do not remove or lift lock after unscrewing.
PAGE 4
For Units with Two Locks Only / For Units with Two Locks Only 8 VeriLock Dummy Cover VeriLock Dummy Cover Interior Remove screws from left lock and dispose of properly. Do not remove lock. Position VeriLock dummy cover around left lock and fasten using #8 x 1" color matched screws provided. Do not over tighten screws. Remove screws from left lock and dispose of properly. Do not remove lock. Position VeriLock dummy cover around left lock and fasten using #8 x 1" color matched screws provided.
PAGE 5
11 Interior Retract tilt latches by pushing lock handle(s) outward and tilt sash up. Close and lock sash. Retract tilt latches by pushing lock handle(s) outward and tilt sash up. Close and lock sash. Verify VeriLock Sensor Function / Verify VeriLock Sensor Function 12 Interior Locked Locked Unlocked Unlocked 1. 2. 3. 4. Raise lower sash from closed position. Indicator light will illuminate for one (1) second. Close lower sash so the lock aligns with the keeper.
PAGE 6
Regulatory Statements / Regulatory Statements Federal Communications Commission (FCC) Part 15 Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference that may be received, including interference that may cause undesired operation. Industry Canada (IC) RSS Statement This device complies with Industry Canada license-exempt RSS standard(s).