Installation Guide

ManualsBrandsAndersen ManualsDoors & Windows72 in. x 80 in. LuminAire White Retractable Screen Door

Emco Enterprises, Inc., is a wholly owned subsidiary of Andersen Corporation. Emco Enterprises, Inc.

manufactures and supports the limited warranties for Andersen

and EMCO

doors. “Andersen”,

Installation Guide

Please Do Not Return Product to Store!

with any questions regarding installation, lost part replacement, or anything else related to your retractable

insect screen purchase. Replacement parts can also be found at: parts.andersenstormdoors.com

Read this entire guide before you begin your installation. If your abilities do not

match the requirements of this installation, contact an experienced contractor.

PLEASE call the Storm Door Solution Center at 844-813-6664,

For installation help please visit www.AndersenLuminAire.com/install

Designed for 32” – 36” wide by 80” tall single hinged doors with suitable mounting surface.

PARTS OVERVIEW

1 2

Your installation kit should contain the following parts.

Andersen SDD, PO Box 853

Des Moines, IA 50306-0853

Rev 10-2017v2 Print in Color

p/n 900106

for Andersen® LuminAire

™

Retractable Insect Screen Door

with SlideAway® Insect Screen System

Screen Housing (one with handle & orange clips)

Latch Housing (one without handle or clips)

Screen Tracks (top and bottom)

End Caps (attached to ends of housings)

Sill Adapter

Orange Installation Clips

Not Shown

Screw Pack containing:

• 1 inch #8 screws (qty 6)

• ½ inch #8 self-tapping screws (qty 3)

• ⁄ inch Drill Bit

• #2 Phillips Bit

To avoid product damage, be sure to unpack and assemble your

retractable insect screen on a soft non-abrasive surface such as

carpet, drop cloth placed on your lawn or cardboard.

IMPORTANT

NOTE: The orange installation clips attached to the Screen

Housing provide product protection during shipping and

installation. DO NOT extend screen from housing or remove

installation clips until instructed.

Summary of content (8 pages)

PAGE 1
Installation Guide for Andersen® LuminAire™ Retractable Insect Screen Door with SlideAway® Insect Screen System Designed for 32” – 36” wide by 80” tall single hinged doors with suitable mounting surface. For installation help please visit www.AndersenLuminAire.com/install Please Do Not Return Product to Store! PLEASE call the Storm Door Solution Center at 844-813-6664, with any questions regarding installation, lost part replacement, or anything else related to your retractable insect screen purchase.
PAGE 2
SAFETY FIRST: Please read and follow all Cautions and Warnings in this guide. WARNING WARNING WARNING Improper use of hand or power tools could result in injury and/or product damage. Follow equipment manufacturer’s instructions for safe operation. Always wear safety glasses. Windows and doors can be heavy. Use safe lifting techniques and a reasonable number of people with enough strength to lift, carry, and install window and door products to avoid injury and/or property damage.
PAGE 3
1 2 3 3 Latch Housing ALL ITEMS DURING THE ASSEMBLY STEPS SHOULD BE LAYING FLAT ON THE GROUND D Screen Track (C/D) IMPORTANT RECEIVING TAB (FITS INSIDE SCREEN TRACK) CHANNEL (FOR SCREEN TRACK) D Receiving Tabs on the Endcaps must slide inside the Screen Track. Product damage may occur if Receiving Tab is forced out-side the screen track. ENDCAP A Visit AndersenLuminAire.com/install to view a video of this step.
PAGE 4
5/8” 1/2” 1” SMS Pan 5/8” 5/8” 2 PLACE AND FASTEN ASSEMBLY INTO OPENING 1/2” 1/2” Tools Recommended: 5/8” 1” 2” 1 1/2” 1/8" 1 1/2” 1/2” SCREW PACK 1/2” 1/2” #8-1" 1” SMS Pan Painted (Qty 6) 1” 2” 1 1/2” 1” Machine Pan Painted 1 1/2” a ! DOOR OPENING HANDLE 1-1/2”bMachineTRIM Flathead !#10 DOOR OPENING HANDLE OR SCREEN HOUSING 5/8” SURFACE DOOR OPENING 1-1/2” Machine Flathead SCREEN HOUSING 2” SMS Pan #12 5/8” SCREW FLANGE 1/2” a With the interior of the screen assembl
PAGE 5
2 PLACE AND FASTEN ASSEMBLY - Continued e f SCREEN HOUSING SCREEN HOUSING SCREW FLANGE SCREW FLANGE LATCH #6 #8 - 1" SCREW 3/4” Machine Pan Painted MOUNTING SURFACE MOUNTING SURFACE 1-1/4” SMS Pan #8 e From the interior of the screen assembly, hold the Screen Housing side f1 Verify the screen assembly is plum, level and square in the door opening ! ! f2 With 1/8" bit provided, predrill through the three holes on the Screen Housing ! side Screw Flange into the Mounting Surface a maximum d
PAGE 6
APPENDIX - STEPS FOR NARROW OPENING AND SUPPORT BLOCKING FOR SILL (if required) Tools Recommended: APPENDIX A A Work Gloves Narrow Opening Modification for Openings less than 31 7/8" wide. Hacksaw Metal File Screen Track (A/B) ! a EXAMPLE (FOR STEP a3 BELOW) W1 If opening width W1 = 29 3/4," W2 = 29 3/4," and W3 = 29 1/2." Take narrowest width = 29 1/2" and subtract from 32 inches.
PAGE 7
FREQUENTLY ASKED QUESTIONS – ANDERSEN® LUMINAIRE™ RETRACTABLE INSECT SCREEN Unlatching Locking/Unlocking How do I open and close the insect screen? Use the Handle to extend insect screen to the other side of door frame. It will automatically latch when fully extended. Slide the Release Lever up or down to unlatch, the insect screen will automatically retract (see Figure 1). RELEASE LEVER LOCK TAB 2.
PAGE 8
LIMITED WARRANTY ANDERSEN® LUMINAIRE™ RETRACTABLE SCREEN DOOR 5 YEAR LIMITED WARRANTY LIMITED WARRANTY ON RETRACTABLE SCREEN DOOR COMPONENTS Emco Enterprises LLC (Emco), an Andersen company, warrants the screen housing, latch housing, screen track, endcap and sill adapter components of the Andersen® LuminAire™ retractable screen door to be free from defects in manufacturing, materials, paint adhesion, and workmanship, under normal conditions, for five (5) years from the date of purchase or as long as the or