AW-NU240 IEEE 802.
Document release Version 0.1 Version 0.2 Version 0.
1. Introduction AzureWave Technologies, Inc. introduces IEEE 802.11b/g/n USB wireless module, AW-NU240. This USB wireless module is a highly integrated wireless local area network (WLAN) solution to let users enjoy the digital content through the latest wireless technology without using the extra cables and cords. It enables a high performance, cost effective, low power, compact solution that easily fits onto one side of a USB. Compliant with the IEEE 802.
3. General Specifications Model Name Product Description WLAN Standard Host Interface Major Chipset Dimension Weight Antenna USB Connector RF Connector Operating Conditions Voltage Temperature Cold start Long time connection Electrical Specifications Frequency Range Modulation Receive Sensitivity Operating Range Operating System Compatibility AW-NU240 IEEE 802.11 b/g/n USB wireless module IEEE 802.11b/g/n, Wi-Fi compliant USB Atheros AR9271L ( MAC/Baseband/RF ) Single chip 50 x 17 x 9.
4-1. Absolute Maximum Ratings Symbol Parameter Max. Rating Unit Vdd3.3V Maximum I/O supply voltage –0.3 to 3.465 V RFin Maximum RF input (reference to 50 Ω) +10 dBm Tstore Storage temperature –20 to 85 °C 4-2. Power Consumption Test Bed DELL VOSTRO 3450 Test OS Windows 7 Ultimate x64 SP1 Test AP D-LINK DIR-855 AZ_AR9271_XP_7.7.0.98_VT_8.0.0.80_WIN7_2.0.0.5 7_20101105 Driver Version 3.3V Test Voltage L0 Mode L1 Mode 44.4 mA N/A 212.0 mA N/A 39.
40* Receiver Packet Test HT 40* 239.6 mA N/A Note. 1. The power consumption data were measured when NB operated in DC (battery) mode. 2. Device not support L1 mode.
5. Connector Pin-out Definitions Pin No. Definition Basic Description Type 1 GND Ground. GND 2 USB_D+ USB Differential signal. Digital 3 USB_D- USB Differential signal. Digital 4 Power 3.3V power supply. Vcc 5 Reset_B Reset if low.
6.
FCC Statement: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. IMPORTANT NOTE: This module is intended for OEM integrator.
LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following " Contains TX FCC ID: MDZAZW9271-240 ". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement has to also be available on the label: This device complies with Part 15 of FCC rules.
