User and Installation Guide 5.
R User and Installation Guide Unpacking: Check that this package contains: One 5.8 GHz Digital Audio transmitter, one 5.8 GHz Digital Audio receiver, two AC adapters, two dual RCA audio cables. Step 1 Connecting the transmitter The transmitter connects to a line-out interface via the supplied RCA cable. Most audio devices provide a line-out interface. If no line-out interface is available, the transmitter can also be connected to other audio outputs by using an appropriate adapter.
R User and Installation Guide Step 2 Placing the transmitter The operating range essentially depends on how many obstacles there are between the transmitter and the receiver. Therefore, it should be carefully considered where to place the transmitter. Below, two examples are given. In the first example, there are 4 walls between the transmitter and the receiver. The transmission may be interrupted.
R User and Installation Guide Step 3 Connecting the receiver The receiver connects to a line-in interface via the supplied RCA cable. Most audio devices, such as amplifiers, provide a line-in interface. If no line-in interface is available, the receiver can also be connected to other audio inputs by using an appropriate adapter. It should be noted that the maximum audio level of the receiver output is 1 Vrms (Vpp ± 1.4 V maximum). Ensure that the connected audio device will accept this audio level.
R User and Installation Guide Step 4 Operating the transmitter and receiver After powering up the transmitter, the transmit light will light for approximately 5 seconds while the transmitter initializes. After initialization, the transmit light will go out. Once audio is detected at the audio input, the transmit light will light and the transmitter will transmit the audio signal. When no audio is present anymore, the transmitter will go into standby mode after approximately 1 minute.
R User and Installation Guide Problems and Solutions Table What Is Possible Why Happening Transmit light of Faulty AC adapter or transmitter does faulty power outlet not light when DC power is applied Transmit light No audio present at goes out after 5 audio input seconds and does not light again Transmitter hung up No audio at receiver Receiver hung up Strong interference Audio at receiver drops out intermittently Unstable power supply Strong interference Low operating range Too many obstacles betwe
R User and Installation Guide Technical Specifications Audio transmission method: Digital Transmitter frequency: 5.8 GHz Signal-to-Noise ratio (A-weighted): typ. 93 dB Dynamic range: typ. 93 dB Frequency response: 1 Hz - 22 kHz Channel separation: typ. 91 dB Harmonic distortion: typ. -88 dB Error correction: 1/2 rate FEC Audio sampling method: 64 times oversampling Transmitted data rate: > 3 Mbps Data available at high-speed data port Max.
Limited warranty WHAT YOUR WARRANTY COVERS This warranty extends only to the original user of the equipment (“you”, ”your”) and is limited to the purchase price of each part. Amphony and it’s affiliated companies (”we”, ”our”, ”us”) warrant this Wireless Transmitter / Receiver Set against defects in materials or workmanship as follows.