AMPAK AP6398XU (Wi-Fi and Bluetooth module) Evaluation Kits User manual Version 1.0 Revision History Date 2019/10/16 AMPAK Technology Inc. Doc. NO: Revision Content Modify figure1 www.ampak.com.tw Revised By Version Ali 1.
1. AP6398XU Evaluation Board Introduction AP6398XU Evaluation board (EVB) likes as figure1. That is designed for IEEE802.11 a/b/g/n 2x2 WLAN with integrated Bluetooth and FM application. It is subject to provide a convenient environment for customer’s verification on WiFi or Bluetooth function. There are many controller pins and reserved GPIO on Evaluation board which describes as below. Figure1. Top view of AP6398XU EVB Interface highlights: 1. U1: AP6398XU SIP module. 2.
WIFI SDIO: Using external pull up resistors depends on the SDIO supply voltage. For 1.8V, the resistance range is 30KΩ~82KΩ. For 3.3V, its range from 21 KΩ~41 KΩ on the four data lines and the CMD line as the following circuitry. VIO_3V3 R7 R6 J8 SD2 SD3 SDCMD GND 3.3V SDCLK GND SD0 SD1 9 1 2 3 4 5 6 7 8 SDIO_D2 SDIO_D3 SDIO_CMD SDIO_CLK SDIO_D0 SDIO_D1 1 R10 R28 R29 2 C10 10uF SDIO_3V3 Golden Finger_9 Figure2.
Figure3. Bluetooth verification connection interface to Host UART Hardware Setup: Refer to Figure3 UART pin definition connects the J1 interface of AP6359S evaluation board to Host UART control interface. Connects an external antenna at SMA connector on the evaluation board. Note to the VDDIO voltage level should be the same as GPIO voltage level of Host CPU. WiFi and Bluetooth software setup: Please follow up software guideline of Ampak official released. AMPAK Technology Inc. Doc. NO: www.ampak.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
1) L’appareil ne doit pas produire de brouillage; 2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Label requirements (Module) If the identification number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module, Contains FCC ID: ZQ6-AP6398XU, Contains ISED ID: 11956A-AP6398XU.
