AMPAK AP6356SDPB_I Carrier board User manual Version 1.0 Revision History Date 2017/08/25 AMPAK Technology Inc. Doc. NO: Revision Content Initial released www.ampak.com.tw Revised By Version Rue 1.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna.
1. AP6356SDPB_I Carrier Board Introduction AP6356SDPB_I Carrier board (EVB) likes as figure1. That is designed for IEEE802.11 a/b/g/n/ac 2x2 WLAN with integrated Bluetooth. It is subject to provide a convenient environment for customer’s verification on WiFi or Bluetooth function. There are many controller pins and reserved GPIO on Carrier board which describes as below. A1 A2 U1 Edag finger Figure1. Top view of AP6356SDPB_I CB Interface highlights: 1. U1: AP6356SDPB_I SIP module. 2.
2. WiFi function verification step WIFI PCIe: Follow PCI Express Mini Card pin outs definitions U2 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43 45 47 49 51 TOP BOT PCIE_WAKEn COEX1 COEX2 CLKREQ# GND REFCLKREFCLK+ GND NC NC GND PCIE_RDN PCIE_RDP GND GND PCIE_TDN PCIE_TDP GND GND VDD3V3 VDD3V3 GND NC NC NC NC VDD3V3 GND 1.5V NC NC NC NC NC GND W_DISABLE PCIE_PERST_L VDD3V3 GND 1.5V NC NC GND USB_DUSB_D+ GND LED_WWAN# LED_WLAN# LED_WPAN# 1.
3. Bluetooth function verification step USB： Hardware Setup: Refer to Figure3 USB pin definition connects the Edge finger of AP6356SDPB_I carrier board to Host USB control interface. Connects an external antenna at I-PEX connector on the carrier board. WiFi and Bluetooth software setup: Please follow up software guideline of Ampak official released. AMPAK Technology Inc. Doc. NO: www.ampak.com.
