AMPAK AP6XXX Evaluation Kits User manual Version 1.2 Revision History Date 2012/12/26 2013/03/07 2013/06/06 AMPAK Technology Inc. Doc. NO: Revision Content Initial released Modify figure1 Modify figure1 www.ampak.com.tw Revised By Version Dora 1.0 Dora 1.1 Dora 1.
1. AP6XXX Evaluation Board Introduction AP6XXX Evaluation board (EVB) likes as figure1. That is designed for IEEE802.11 a/b/g/n/ac WLAN with integrated Bluetooth, FM, NFC and GPS application. It is subject to provide a convenient environment for customer’s verification on WiFi or Bluetooth function. There are many controller pins and reserved GPIO on Evaluation board which describes as below. Figure1. Top view of AP6XXX EVB Interface highlights: 1. U1: AP6XXX SIP module. 2.
9. J11: WL_VIO power path for 1V8 or 3V3 selection. 10. SW1: Power on/off switch. 11. CN1: NFC interface connects with NFC antenna. 12. S1: SMA connector let RF signal in/out path, you could connect with RF cable or Dipole antenna. 13. S2: SMA connector let GPS RF signal input, you could connect with GPS antenna. 14. Ct1: WLAN and BT control pins, strongly recommended WL_HWAKE(IRQ) connected to MCU. 15. Ct2: NFC control pins, strongly recommended N_WAKE and N_H_WAKE connected to MCU. 2.
3. Bluetooth function verification step Figure3. Bluetooth verification connection interface to Host UART Hardware Setup: Refer to Figure3 UART pin definition connects the J1 interface of AP6XXX evaluation board to Host UART control interface. Connects an external antenna at SMA connector on the evaluation board. Note to the VDDIO voltage level should be the same as GPIO voltage level of Host CPU. WiFi and Bluetooth software setup: Please follow up software guideline of Ampak official released.
Federal Communications Commission (FCC) Statement You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
FCC RF Radiation Exposure Statement : 1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This module has been granted modular approval for mobile applications.
