IOT-500 5" Risc-based Panel PC 5" 物聯網/車聯網資料收集器 User Manual 使用手冊
Version 1.0 Copyright Notice Copyright © 2015 Amobile Intelligent Corp. All Rights Reserved. This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic, or other means in any form without prior written permission of the manufacturer. Disclaimer The information in this document is subject to change without prior notice in order to improve the reliability, design and function.
Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(a) This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
NCC警語： 根據NCC低功率電波輻射性電機管理辦法 規定: 第十二條 經型式認證 合格之低功率射頻電機，非經許可，公司、商號或使用者均 不得擅自變 更頻率、加大功率或變更原設計之特性及功能。 第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經 發現有干 擾現象時，應立即停用，並改善至無干擾時方得繼續使用。 前項合法通信，指依電信法規定作業之無線電通信。 低功率射頻電機須 忍受合法通信或工業、科學及醫療用電波輻射性電機 設備之干擾。 「減少電磁波影響，請妥適使用」。 詳細功能說明書請參閱磐旭智能網站 amobile-solutions.
Open Your Box IOT-500 Risc-Based Panel PC DC power adapter w/ 2-pin power terminal User Manual 7 3 1 2 5 4 8 9 10 6 11 14 13 15 12 1 2.0 megapixel camera 9 2 Microphone 10 2 x USB 2.0 ports 10/100 Mbps RJ-45 LAN port 3 5-point projected capacitive touch screen 11 DB-9 RS-232/422/485 port 4 Integrated 0.8W speaker 12 Power/Resset button • Press and hold to power on/off the device. • Press to suspend or resume the device. 5 4x 3.3V DIO, 1 x CAN 2.
Install SIM & microSD Cards To install a SIM card to the device, locate the SIM card slot on the side and insert the card following the direction as shown below. Push the SIM card into the card slot until it locks into place. To remvoe the SIM card, just push the SIM card in to eject it from its slot. Power Connection To connect the device to a power source, connect the 2-pin terminal block plug of the power adapter to the 2-pin terminal block receptacle on the device.
Connector Pinouts PWPIN Description: Power Input Connector Connector Type: 2-pin Terminal Block Pin Description 1 Power_GND 2 +12V-24V 2 1 GPIO and CAN Bus Description: Digital General Purpose Signal Input/Output and CAN Connector Type: 4x 3.3V Digitial GPIO connector and 1 x CAN 2.
IOT-500概覽 包裝內容: IOT-500 RISC架構平板電腦 DC 變壓器 (2-pin電源端子座) 使用手冊 7 3 1 2 5 4 8 9 10 6 11 14 13 15 12 1 2百萬畫素相機 9 2 麥克風 10 2 x USB 2.0 連接埠 10/100 Mbps RJ-45 LAN 網路連接埠 3 5點觸控投射電容式螢幕 11 DB-9 RS-232/422/485 連接埠 4 內建0.8W 喇叭 12 Power/Resset 按鈕 • 長按可開啟/關閉裝置 • 按一下可進入待機模式/喚醒裝置 5 4x 3.3V DIO, 1 x CAN 2.0b / OBD-II 13 Wi-Fi / 藍芽天線 *使用時請拆下保護蓋.
安裝 SIM卡 若要安裝SIM卡，請將SIM卡依下圖指示方向，將卡片插入裝置後側的SIM卡插 槽，然後將卡片直推到底，確定完全插入。 若要移除SIM卡，將SIM卡往前輕推，卡片會稍微退出，即可取出卡片。 連接電源 將變壓器的2-pin端子座插入裝置後 側的DC電源輸入孔，然後將電源變 壓器接上電源，接上電時裝置會自 動開啟。 5
Pin腳定義 PWPIN 說明: 電源輸入孔 連接埠類型: 2-pin端子座 Pin 說明 1 Power_GND 2 +12V-24V 2 1 GPIO 及 CAN Bus 說明: 通用型輸入輸出及 CAN 連接埠類型: 4x 3.3V GPIO 連接埠及 1 x CAN 2.
產品規格 產品額定電壓 / Rating Voltage: D.C. 12~24Vdc / 2A 操作溫度範圍 / Operate temp.: -10~45℃ 防水防塵等級 / water and dust-proof.
This page is intentionally left blank.
