User's Guide

Important - Safety instructions
Read these instructions carefully and keep for future reference. Note all warnings.
The product contains no user-serviceable parts. Refer all servicing to qualified
service personnel.
Handle the product with care and do not attempt to dismantle the product.
Do not expose the product or its accessories to any liquids, rain or moisture.
Do not locate the product near a heat source and do not block ventilation holes:
the product will become warm during operation. Allow at least 10 cm (4”) around
the product for air circulation.
Do not locate the product where it may be subject to physical shock, vibration or
where the product may fall over.
Do not place the product on soft furnishings or carpets.
Only use the power supply provided by the manufacturer. The use of any other
type of power supply may invalidate any approval or warranty applying to the
product and may be dangerous. If the power supply does not match your local
system, contact your product supplier.
Protect the power supply cord from damage.
The disconnect device is the power supply cord. Removing the power supply cord
from the mains supply isolates the product from the mains.
Disconnect the product from the mains supply if left unused for long periods of
time or during electrical storms.
Disconnect the product before cleaning, and use a dry cloth only.
Only use attachments and accessories specified by the manufacturer.
The product is for indoor use only.
1. Power/Activity LED:
Blue = on.
Blue flashing = IR command received / Kamai 7XM starting up.
Red = standby.
Warning! Before connecting or disconnecting any cable switch
off all system devices (TV, A/V Amplifier, etc) and disconnect
from the mains electrical supply. The Kamai 7XM provides options
for connecting audio and video to your TV:
HDMI (recommended): best quality. Connect a HDMI cable to the
HDMI output of Kamai 7XM and to the HDMI input of your TV.
Analogue A/V: good quality. Composite video (SD only) with
analogue audio left/right. Connect the 3.5 mm jack to the A/V
OUT port of Kamai 7XM and connect the yellow RCA plug to the
yellow video port on your TV. Connect the red and white RCA
plugs to the red and white audio ports on your TV.
Connecting to a Network
Select from one of the following networking options.
Option 1
Connect an Ethernet cable from Kamai to a
cable/DSL modem or Network Router.
(Router not included, cable is optional and may not be included)
Option 2
Connect your Kamai to MoCA Network.
1. MoCA cable input.
2. Ethernet port.
3. Analog A/V output.
4. S/PDIF optical output.
5. HDMI output.
6. USB port.
7. DC power input 12 V 2 A.
8. Reset button. No function in normal use.
Only use under guidance from your service provider.
Contents
The Kamai 7XM is supplied with the correct power adapter for your
local system. The package may also contain optional accessories
shown below, depending on your service provider.
The Kamai 7XM is protected with a clear plastic film. This should be
removed before use.
1 2 3 4 5 6 7 8
HDMI
Analogue
A/V
1. Overview of the Kamai 7XM 2. Connecting the Kamai 7XM to a TV
Optional accessories
Kamai 7XM User Guide
Remote control
and batteries
HDMI cable
3.5 mm jack to
3 x RCA cable
Ethernet cable