COCKY 3180A-AGD7 Lithium ion battery charger for electric scooter Instruction manual TWANG YANG MOTOR CO. LTD. Headquarters : No.35, Waning St.
Special warnings and precautions for use : ® This charger is intended to use on the electric scooter and the COCKY ION EX rechargeable battery early. If the output cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Read this booklet thoroughly before using Specification : Input Voltage 100 240 Vac Output Voltage 574 Vdc Rated Current 3 A Frequency 50-60 Hz Output Power (Max) | 172.2 w Battery Capacity 13 Ah Ambient Temperature -10 40 100-240Vac Storage Temperature Attitude 2000 Meters Weight 06 Kg Color White Dimension | mm Cone | Ly FEATURES: ® Lithium ion battery charger ® Using microcomputer control: When an abnormal state occurs, the charger will be disconnected from the battery to protect the battery.
LED Indicator : Standby mode The charger is not connector to the battery. ® Charging made | Charger charging the battery. When the battery is fully charged, the internal Fully charge switch of the charger will be disconnected and will not continue to charging the battery. Error mode: Battery over voltage Red flash 1 times protection .
Trouble Shooting: Status Probable causes Exclusion method No indicator light Used in outdoors and under sun exposure, Unplug the power cord.and reconnect it. Also, use the battery charger in a cool and ventilated place. Power cord end is not Confirm that there is No output voltage ! in real contact. contact complete. Battery still cannot be fully charged after — charging for along 5 terry 5 aging or Replace the new piling damaged. battery. (Red flash 2 times) The battery has not been Battaryinanover.
Installation steps (With universal battery WiFi) — a2 ane [frontward Installation steps : 1.Place the battery on the universal battery charger and confirm that the charger output connector is properly connected to the universal battery charger. 2.Connect the AC parer card to the AC socket of the charger. 3.Plug the AC power cord into the power outlet, Remove steps: 1 Remove the AC power cord from the power outlet. 2, Remove the charger output connector farm the universal battery charger. 3.
Installation steps (With electric scooter) Deicer scooter Curing interface Installation steps : 1. Confirm that the charger output connector is properly connected to the electric scooter. 2. Connect the AC power cord to the AC socket of the charger. 3.Plug the AC power cord into the power outlet Remove steps: 1. Remove the AC power cord from the power outlet. 2. Remove the Charger output connector from the electric scooter.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: {1} This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation, This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.