Installation Instructions Mira 45 w w w . a m i c o .
Table of Contents 2 General Information 3 Safety instruction 3 Abbreviation and Symbols 4 Assembly and Installation MIRA 45 Single Ceiling 5 Assembly and Installation MIRA 45 Double Ceiling 6 Assembly and Installation MIRA 45 Wall Mount 7 Assembly and Installation MIRA 45 Floor Stand 8 Head Assembly 8 Putting into Operation 9 Care, Maintenance and Repair 9 Technical Data 11 Disposal 11 Amico Lighting Solutions
General Information Operating manual Operating manual (GB) (GB) English Designated Use English 1. General Information U U Intended Purpose Minor surgical luminaire Use (Treatment light) – light for local illumination of the patient’s body during 1. General Information 1.1. Designated diagnosis or treatment. It is not intended for use in operating theatres. 1.1.1. Intended purpose 1.1. Designated Use Minor surgical luminaire (Treatment light) – light for local illumination of the 1.1.1.
Abbreviations and Symbols (GB) Operating manual Operating manual (GB) Operating manual 3. 3. Abbreviation(GB) and Symbols Abbreviation(GB) and Symbols 3. Abbreviation and Symbols Operating manual Attention, observeobserve accompanying documents Attention, accompanying documents Attention, observe accompanying documents Operating manual (GB) Device of international protection I (protective international protection class Iclass (protective earth)earth) Operating manual Device of (GB) 3.
Assembly and Installation MIRA 45 Single Ceiling Operating manual Operating manual (GB) (GB) 4. Assembly and Installation MIRA Note:out Only qualified technicians should carry ou Only qualified technicians should MIRA carry MIRA 45 installation. 4. Note:Assembly and Installation 45 Single Ceiling Mounting steps Two people are 45 required for assembling the MIRA 4 Note: Only qualified technicians should carry out MIRA installation.
Operating manual (GB) Assembly and Installation MIRA 45 Double Ceiling 5. Assembly and Installation MIRA 45 Double Ceiling Note: Only qualified technicians should carry out MIRA 45 installation. Two people are required for assembling the MIRA 45 Double Ceiling. The supply voltage must correlate with the voltage noted on the fixture’s rating label. The ceiling fitting is to be used exclusively with ceilings that are either solid, supplied withtechnicians a suitable high-strength ceiling-mounting solution.
(GB) Assembly and Installation MIRA 45 Wall Mount Operating manual Operating manual Detailed view 1 Detailed view 1 6. (GB) Assembly and Installation MIRA 45 Wall Mount Note: Only qualified technicians should carry out MIRA 45 installation. Installation MIRA 45 Mount. Wall Mount Two6.peopleAssembly are required and for assembling the MIRA 45 Wall The supply Note: Only qualified technicians should carry out MIRA 45 installation. Note: Only qualified technicians should carry out MIRA 45 installation.
Assembly and Installation MIRA 45 Floor Stand Operating manual (GB) Operating manual (GB) the support into the castor base 45 andFloor tightenStand the set-screws 7. 1. Insert Assembly andtube Installation MIRA (support disc, screws - 1the x M8, 1 x M5 – and serratedthe washer). c Insert the support tube into castor base and tighten set-screws (support disc, screws - 1xM8, 1 x M5 – and serrated washer). 7. and Instal d Place themanual spring-loaded arm on the support tube and align theAssembly holes.
Putting into Operation (GB) Operating manual (GB) Operating manual 9. Operating manual Operating manual Putting into Operation Before placing the light into operation, the user has to check whether mains frequency specified on the rating plate are identical. Before placing the light into operation, (GB) the user has to check whether mains voltage and 9. intospecified Operation voltage Putting and frequency on the rating plate are identical.
Operating manual (GB) 10.4. Troubleshooting Troubleshooting, Cleaning and Disinfection 1. Check the on/off Switch 2. 3. 4. Check the electrical supply Check the halogen lamp, change if necessary Check all terminal connections in the fixture Also check the voltage on the connecting terminal. Troubleshooting 10.5. Cleaning 1. Check the on/off Switch Note: The periodical cleaning of the face-plate ensure a better light efficiency. Use a usual glass cleaner.
Technical Data and Disposal Operating manual (GB) 11. Technical Data Technical Data Electrical values: Electrical values: Operating manual Nominal voltage: 120 120VV~~ Nominal voltage: 50/60 Hz Frequency range Frequency range 50/60 Hz (GB) 50 W consumption: PowerPower consumption: 50 W 120 V / 12 V Integrated electronic transformer Integrated electronic transformer 120 V / 12 V Luminous values: 11. Technical 45’000 lux Central illuminanceData (0.
www.amico.com Amico Lighting Solutions | www.amico.com 85 Fulton Way, Richmond Hill Ontario, L4B 2N4, Canada 71 East Industry Court, Deer Park NY 11729, U.S.A Toll Free Tel: 1.877.264.2697 Toll Free Fax: 1.866.440.4986 Tel: 905.763.7778 Fax: 905.763.8587 Email: info@amico.com C US LISTED INSTALL INSTR.