User Instructions

Table Of Contents

C OMP O NENTS, INCO RPO R A TED

American

echnology

Wireless Charging Technology

INSTRUCTIONS

Create a cutout in a surface for the charger to drop into, the

cutout should measure 4.5” x 2.75”.

Place wires first into cutout, connect the black wire to ground.

Connect the red wire to a 12 volt 2 amp power source.

Clean surface and charger where they will meet. Use

adhesive to seal charger to top of cutout surface.

Place your phone down (back towards the charger), your

phone should indicate that charging has started.

NOTE: PACKAGING OF WIRELESS CHARGER MAY CHANGE PER USE CASE NOTE: PACKAGING OF WIRELESS CHARGER MAY CHANGE PER USE CASE

The Product Marketing Name is:Wireless Charger

PAGE 1
EN 1 INSTRUCTIONS 3 American Technology 1 Create a cutout in a surface for the charger to drop into, the cutout should measure 4.5” x 2.75”. 2 Place wires first into cutout, connect the black wire to ground. Connect the red wire to a 12 volt 2 amp power source. COMPONENTS, INCORPORATED Wireless Charging Technology Clean surface and charger where they will meet. Use adhesive to seal charger to top of cutout surface.
PAGE 2
REGULATORY INFORMATION INFORMATIONS REGLEMENTAIRES FCC Statement This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions: (1) this device may not cause harmful interference. and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
PAGE 3
RSS Statement (Canada) This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation. Science and Economic Development Cana:la·s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference. including interference that may cause undesired operation of the device. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.